Ge Dishwasher: not filling

Professional Repair Guide

What is this symptom?

Is your GE dishwasher running a cycle but not filling with water? If the tub remains dry and you hear no water flow sounds, it's likely due to a faulty or clogged water inlet valve. This common issue can lead to unclean dishes and frustration during your dishwashing routine.

Urgency: Medium

Possible Causes

Faulty or clogged water inlet valve

How to Identify: Dishwasher starts but no water enters; check if valve screen is dirty or valve solenoid lacks continuity.

Part: Water inlet valve

Defective main control board

How to Identify: Other systems work but the inlet valve doesn’t get signal to open, diagnostic tests show board not powering valve.

Part: Control board

Frequently Asked Questions

Why is my GE Dishwasher not filling?
The most common cause is a faulty or clogged water inlet valve, preventing water from entering the tub.
How do I fix GE Dishwasher not filling myself?
Unfortunately, there are no DIY solutions available for this issue.
How much does it cost to fix not filling?
Professional repair costs can vary; consult a technician for an accurate estimate.
When should I call a technician for not filling?
Call a technician if the dishwasher remains nonfunctional, as the water inlet valve may need replacement.

References & Sources

Community Analytical Insights

Analysis based on real user discussions from appliance repair communities

Can I Fix This Myself?

75%
DIY Success Rate Difficulty: DIY

Common Issues Reported by Users

  • Clogged water inlet valve
  • Faulty float switch
  • Water supply issues (e.g., closed valve, kinked hose)

User Suggested Solutions

  1. Check the water inlet valve for clogs. Disconnect the dishwasher from power and water supply. Remove the inlet valve and inspect for debris. Clean or replace as necessary.

  2. Test the float switch. Remove the float cover and ensure the float moves freely. If stuck, clean it. If defective, replace the float switch.

  3. Inspect the water supply line. Ensure the water supply valve is fully open and check for kinks in the hose. If issues are found, correct them.

Analysis based on 1 community discussions
View Sources

Data compiled from real discussions on r/appliancerepair and r/Appliances:

  1. GE PDT715 Dishwasher starts then stops, code 371 - fills in ...

Community Discussions

Starts then stops after a couple minutes

Cleaned the pressure switch and cleared the hole in the black part.

DIY View on Reddit →

Source: Reddit r/appliancerepair

User Comments (0)

Share your experience or solution below.

Be the first to comment!