Aeg Washing Machine: not heating

Professional Repair Guide

What is this symptom?

Is your AEG washing machine not heating water? If your washer runs a cycle but the water doesn't reach the desired temperature, and your clothes feel cold or lukewarm, you're likely facing a heating issue. This could be due to a faulty heating element, which is a common problem among AEG models. Addressing this issue promptly is essential for effective laundry.

Urgency: Medium

Possible Causes

Faulty heating element (electric heater)

How to Identify: Water remains cold during heating phase; continuity test with multimeter shows open circuit; known common failure in AEG machines and others.

Part: Heating element

Preventive Maintenance

Run periodic highâ€‘temperature wash: Mineral buildup and heater element scale
Frequency: monthly
Check internal wiring connections annually: Loose wire failures affecting heating functions
Frequency: annually

Frequently Asked Questions

Why is my AEG Washing Machine not heating?

Commonly, a faulty heating element is the cause of your AEG washing machine not heating.

How do I fix AEG Washing Machine not heating myself?

No DIY solutions are recommended for this issue; professional assessment is advised.

How much does it cost to fix not heating?

The cost of repairing a heating issue can vary; consult a technician for an accurate estimate.

When should I call a technician for not heating?

If your AEG washing machine is not heating, it's best to call a technician to diagnose and fix the issue.

References & Sources

Community Analytical Insights

Analysis based on real user discussions from appliance repair communities

Can I Fix This Myself?

65%

DIY Success Rate Difficulty: Either

Common Issues Reported by Users

Faulty heating element
Defective temperature sensor
Issues with the control board

User Suggested Solutions

Test and replace the heating element. Disconnect the machine, remove the back panel, locate the heating element, use a multimeter to check for continuity, and replace if faulty.
Check and replace the temperature sensor. Access the sensor by removing the front panel, use a multimeter to test the sensor, and replace it if it shows incorrect readings.
Inspect the control board for signs of damage or burnt components. If found, replace the control board entirely. This may require professional assistance if you are not experienced.

Analysis based on 1 community discussions
View Sources

Data compiled from real discussions on r/appliancerepair and r/Appliances:

Bypass heating element AEG Lavamat 74630 Update Model

Community Discussions

stops at the heating part of the cycle, failed element test with E61, E52 motor error

Bypassed heating element using a resistor, machine runs more reliably but still fails element test.