Whirlpool Dryer Error F10

⚡ Quick Answer: The Whirlpool dryer F10 error code indicates a potential malfunction in the control board, which may prevent the dryer from starting or cause it to st... ✅ DIY Fixable

What Does Error F10 Mean?

The Whirlpool dryer F10 error code indicates a potential malfunction in the control board, which may prevent the dryer from starting or cause it to stop mid-cycle. This issue is often reported in Duet models and can be associated with problems in the control or motor circuitry.

Common Symptoms:

  • Dryer stops functioning and displays F10
  • Error persists after powering cycle
  • Commonly occurs on Duet models

Possible Causes

  • Control/Motor circuitry issue (community reports) (low)

How to Fix Error F10

DIY Fix Basic power reset and check

  1. Turn off the dryer and unplug it from the wall.
  2. Wait at least 30 minutes (official Whirlpool support suggests about half an hour).
  3. Plug dryer back in and attempt to restart a drying cycle.
  4. Observe if F10 reappears.

Technician Only Diagnostic inspection of control and motor circuits

  1. Access the dryer’s control board and motor control unit.
  2. Test wiring connections for continuity and check for loose, burnt, or damaged wiring.
  3. Use a multimeter to check continuity of suspected components such as the motor, thermal cutoffs, and main control board.
  4. Replace faulty control board or motor control board if confirmed.
  5. Verify drum motor and related circuitry are operating within specification.

Parts needed: Main control board, Motor control unit, Wiring harness

🛑 When to Call a Pro:
  • After repeated appearance of F10 despite power resets
  • If there’s evidence of burning smells or visible electrical damage
  • If you are not comfortable performing electrical diagnostics yourself

Technical Specifications

wattage N/A
component Control Board
resistance N/A
part_number WPW10110641
voltage_rating 120V AC

Common Questions

What does F10 error mean on whirlpool dryer?

F10 indicates a control board malfunction, causing the dryer to fail to start or stop mid-cycle.

Can I fix whirlpool dryer F10 error myself?

Yes, try performing a power reset: unplug the dryer, wait 30 minutes, then plug it back in.

How much does it cost to fix F10 error?

The estimated repair cost ranges from $150 to $400, depending on parts and labor.

When should I call a technician for F10?

Call a technician if F10 persists after resets, if you notice burning smells, or if you're uncomfortable with electrical diagnostics.

Sources & References

Data last verified: 2026-01-10

User Comments (0)

Share your experience or solution below.

Be the first to comment!