Whirlpool Dryer Error F05

⚡ Quick Answer: F05 means whirlpool dryer error F05 indicates a malfunctioning temperature sensor, which may cause the dryer to stop mid-cycle or ... This is typically a DIY fix.

What Does Error F05 Mean?

whirlpool dryer error F05 indicates a malfunctioning temperature sensor, which may cause the dryer to stop mid-cycle or fail to heat properly.

Common Causes

  • Temperature Sensor (60% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Temperature Sensor

    Locate the temperature sensor, usually found near the heating element. Use a multimeter to check for continuity. If there is no continuity, the sensor needs replacement.

    Ensure the dryer is completely cooled down before starting this check.

  2. Step 2: Remove the Old Sensor

    Disconnect the wires from the faulty temperature sensor and use a screwdriver to remove it from its mounting. Be cautious not to damage surrounding components.

    Take a photo of the wiring before disconnecting for easier reassembly.

  3. Step 3: Install the New Temperature Sensor

    Position the new temperature sensor in place and secure it with screws. Reconnect the wires according to the photo taken earlier.

    Ensure all connections are tight to avoid future issues.

  4. Step 4: Test the Dryer

    Plug the dryer back in and run a short cycle to ensure it heats properly and the error code does not reappear.

    Monitor the dryer for any abnormal sounds or behaviors during the test.

How to Reset

To reset the F05 error, unplug the dryer for 1 minute, then plug it back in and run a test cycle.

Technical Specifications

wattage N/A
component Temperature Sensor
resistance 10-15 ohms
part_number WPW10150130
voltage_rating 120V AC

Frequently Asked Questions

Can I replace the temperature sensor myself?

Yes, replacing the temperature sensor is a straightforward task that most homeowners can handle with basic tools.

How much does a new temperature sensor cost?

A replacement temperature sensor typically costs between $20 to $50, depending on the model.

What causes the F05 error in my whirlpool dryer?

The F05 error is primarily caused by a faulty temperature sensor that fails to provide accurate readings to the control board.

Should I call a professional if the error persists?

Yes, if the error continues after replacing the sensor, there may be a deeper issue that requires professional diagnosis.

When should I expect my dryer to start working again?

After replacing the temperature sensor and testing, your dryer should function normally immediately if the installation was successful.

User Comments (0)

Share your experience or solution below.

Be the first to comment!