Samsung Dishwasher Error TE

⚡ Quick Answer: TE means Samsung Dishwasher error TE indicates a failure in the temperature sensor, often resulting in the dishwasher not heating... This is typically a DIY fix.

What Does Error TE Mean?

Samsung Dishwasher error TE indicates a failure in the temperature sensor, often resulting in the dishwasher not heating water properly or displaying erratic temperature readings.

Common Causes

  • Temperature Sensor (60% likelihood)
  • Wiring Issues (30% likelihood)
  • Control Board Malfunction (10% likelihood)

Troubleshooting Steps

  1. Step 1: Check the Temperature Sensor

    Locate the temperature sensor, usually found near the heating element. Use a multimeter to test its resistance. If it reads outside the expected range (typically 10-30 ohms), it needs replacement.

    Make sure to take note of the wiring configuration before disconnecting.

  2. Step 2: Inspect Wiring Connections

    Examine the wiring connected to the temperature sensor for any signs of damage or corrosion. Repair or replace any damaged wires to ensure proper connectivity.

    Use wire strippers to cleanly remove damaged sections.

  3. Step 3: Test the Control Board

    If the sensor and wiring are intact, check the control board for any visible damage or burnt components. If necessary, consult the service manual for testing procedures.

    A multimeter can help verify if the control board is sending the correct signals.

  4. Step 4: Replace the Temperature Sensor

    If the sensor is faulty, replace it with a new one. Ensure all connections are secure and test the dishwasher to confirm the error is resolved.

    Always use a compatible replacement part to avoid further issues.

How to Reset

To reset the error, turn off the dishwasher and wait for 5 minutes. Then, turn it back on and check if the error persists.

Technical Specifications

wattage N/A
component Temperature Sensor
resistance 10-30 ohms
part_number DC47-00019A
voltage_rating 120V AC

Frequently Asked Questions

Can I replace the temperature sensor myself?

Yes, if you have basic tools and follow the instructions carefully, you can replace the temperature sensor.

How much does it cost to fix the TE error?

The cost can vary, but replacing the temperature sensor typically ranges from $50 to $150, depending on parts and labor.

What causes the Samsung Dishwasher error TE?

The error is primarily caused by a malfunctioning temperature sensor, but wiring issues or control board failures can also contribute.

Should I call a professional for the TE error?

If you're uncomfortable with electrical components or if the issue persists after your attempts, it's best to call a professional.

When should I expect the TE error to clear?

The error will clear once the faulty component is replaced and the dishwasher is reset.

User Comments (0)

Share your experience or solution below.

Be the first to comment!