Samsung Dishwasher Error BE

⚡ Quick Answer: BE means Samsung Dishwasher error BE indicates a malfunction in the drain pump, often accompanied by unusual noises during operat... This is typically a DIY fix.

What Does Error BE Mean?

Samsung Dishwasher error BE indicates a malfunction in the drain pump, often accompanied by unusual noises during operation.

Common Causes

  • Drain Pump Assembly (50% likelihood)
  • Blocked Drain Hose (30% likelihood)
  • Faulty Control Board (20% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Drain Pump Assembly

    Remove the lower spray arm and filter to access the drain pump. Check for any debris or blockages that may prevent the pump from operating.

    Use a flashlight to see inside the pump assembly clearly.

  2. Step 2: Check the Drain Hose

    Trace the drain hose from the dishwasher to the sink drain. Look for kinks or clogs that could impede water flow.

    Disconnect the hose and run water through it to ensure it's clear.

  3. Step 3: Test the Drain Pump Motor

    Using a multimeter, check the resistance of the drain pump motor. If it reads infinite resistance, the motor is likely faulty and needs replacement.

    Ensure the dishwasher is disconnected from power before testing.

  4. Step 4: Inspect the Control Board

    Look for any visible signs of damage or burnt components on the control board. If necessary, consult a professional for further testing.

    A faulty control board may require professional replacement.

  5. Step 5: Reassemble and Test

    After addressing any issues, reassemble the dishwasher components and run a short cycle to check if the error persists.

    Keep an eye on the performance during the test cycle.

How to Reset

To reset the BE error, press and hold the Start/Cancel button for 3 seconds. If the error returns, further investigation is needed.

Technical Specifications

wattage 60W
component Drain Pump Assembly
resistance 10-30 ohms
part_number DC97-16350A
voltage_rating 120V AC

Frequently Asked Questions

Can I fix the BE error myself?

Yes, if you have basic tools and follow the troubleshooting steps, you can address the issue.

How long does it take to fix the BE error?

Typically, it takes about 45-60 minutes to diagnose and repair the issue.

What causes the BE error in Samsung dishwashers?

The BE error is usually caused by a malfunctioning drain pump, a blocked drain hose, or a faulty control board.

Should I call a professional if the error persists?

Yes, if you cannot resolve the issue after following the troubleshooting steps, it's best to consult a professional.

What happens if I ignore the BE error?

Ignoring the BE error can lead to water pooling in the dishwasher, potentially causing further damage.

User Comments (0)

Share your experience or solution below.

Be the first to comment!