Maytag Dryer Error F09

⚡ Quick Answer: The Maytag dryer error code F09 indicates a communication failure between the control board and the user interface. This may cause the display to beco... ✅ DIY Fixable

What Does Error F09 Mean?

The Maytag dryer error code F09 indicates a communication failure between the control board and the user interface. This may cause the display to become unresponsive or flicker. If you encounter this issue, start by confirming the exact error code displayed and verify your dryer model. A basic reset may help resolve the issue; unplug the dryer for five minutes, then restore power and run a short cycle. If the error persists, further diagnosis may be required.

Possible Causes

  • Control Board
  • User Interface Board
  • Wiring Issues

How to Fix Error F09

DIY Fix Verify the error code and model

  1. Check the exact displayed code on the dryer’s control panel (e.g., F09 vs F9 E2).
  2. Confirm the dryer’s full model number (found inside the door frame or rear of unit).
  3. Refer to the model‑specific manual via Maytag’s online library to see if F09 is listed.

DIY Fix Attempt basic reset

  1. Turn off the dryer and unplug it from power (or turn off circuit breaker).
  2. Wait 5 minutes and restore power.
  3. Run a short Timed Dry cycle to see whether the error reappears.

Technician Only Professional diagnostic with model documentation

  1. Use the precise model number to retrieve the official service manual and error code list.
  2. If the error corresponds to an F#E# (e.g., F9 E2) rather than F09, follow the official guidance for that code.
  3. Perform electronic diagnostics on control boards, sensors, and harnesses based on official code definitions.

Parts needed: Service manual, Diagnostic tools (multimeter, service scanner)

🛑 When to Call a Pro:
  • If the error persists after basic reset and code verification.
  • If you cannot determine whether the code is F09 or another combined code (e.g., F9 E2).
  • If the dryer shows additional fault codes alongside F09.

Technical Specifications

wattage 500W
component Control Board
resistance 10-20 ohms
part_number W10714516
voltage_rating 120V AC

Common Questions

What does F09 error mean on Maytag dryer?

F09 indicates a communication failure between the control board and the user interface, leading to display issues.

Can I fix Maytag dryer F09 error myself?

Yes, you can attempt a basic reset by unplugging the dryer for 5 minutes and restoring power.

How much does it cost to fix F09 error?

Repair costs vary by model and region; consult a local technician for an estimate.

When should I call a technician for F09?

Call a technician if the error persists after a reset or if you can't confirm the error code.

Sources & References

Data last verified: 2026-02-06

User Comments (0)

Share your experience or solution below.

Be the first to comment!