Gorenje Washing Machine Error F1
⚡ Quick Answer: The Gorenje washing machine F1 error indicates a fault in the temperature sensor circuit, causing the machine to fail in heating water. This error typ... ✅ DIY Fixable
What Does Error F1 Mean?
The Gorenje washing machine F1 error indicates a fault in the temperature sensor circuit, causing the machine to fail in heating water. This error typically appears shortly after starting a wash cycle, resulting in the program completing without reaching the set temperature. The issue may stem from an open or short circuit in the temperature sensor (NTC), affecting the machine's ability to fill and heat water properly.
Common Symptoms:
- Error appears shortly after wash start
- Wash programme completes without water heating
- Machine won’t reach the set temperature
Possible Causes
- Temperature sensor (NTC) circuit open or short (medium)
How to Fix Error F1
DIY Fix Basic checks for F1 error
- Turn off and unplug the machine.
- Check that the water supply and connections are normal and no error persists after restart.
- Observe if F1 reappears consistently after starting a wash cycle.
Technician Only Diagnose and repair temperature sensor circuit
- Disconnect power and remove rear or access panel.
- Locate the temperature sensor and inspect its wiring and connector for damage.
- Measure sensor resistance with a multimeter (compare with specification).
- Replace the temperature sensor if open/short detected.
- Inspect and repair wiring harness and connectors to the control board as needed.
- If sensor and wiring are good, test control module inputs; replace control board if confirmed faulty.
Parts needed: Temperature sensor (NTC), Wiring harness/connector, Control board (if needed)
- If the user lacks tools or experience to safely inspect electrical components.
- If error persists after basic checks and the machine still displays F1.
Next step
Choose the next step for F1
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Temperature Sensor
Monitors the internal temperature to ensure correct operation and prevent overheating.
- Typical part-only price
- $15 - $35
- DIY difficulty
- Easy
- Estimated time
- 15-30 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Main Control Board
The central brain of the appliance that controls all components, cycles, and timings.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | 50W |
|---|---|
| component | Water Inlet Valve |
| resistance | 500-1500 ohms |
| part_number | Gorenje 123456789 |
| voltage_rating | 220V AC |
Common Questions
What does F1 error mean on gorenje washing machine?
F1 error indicates a temperature sensor circuit issue, leading to no water heating.
Can I fix gorenje washing machine F1 error myself?
Yes, check water supply and connections, then restart the machine to see if the error persists.
How much does it cost to fix F1 error?
Repair costs range from $30 to $250+, depending on parts and service rates.
When should I call a technician for F1?
Call a technician if the error continues after basic checks or if you're unsure about inspecting electrical components.
Data last verified: 2026-04-23
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!