Maytag Washing Machine: not completing cycle

Professional Repair Guide

What is this symptom?

Is your Maytag washing machine not completing its cycle? This common issue often occurs when the washer stops mid-cycle, resulting in pauses or error codes. The most frequent causes include an unbalanced load or a faulty lid switch. Understanding these issues can help you troubleshoot the problem effectively.

Urgency: Medium

Possible Causes

Unbalanced load triggering self‑correction/stop

How to Identify: Washer stops during spin or transition, loud vibration or shaking, clothes unevenly distributed in drum

Part: Load sensing system / imbalance detection

Faulty lid switch or door latch assembly

How to Identify: Cycle stops when lid is closed/appears closed; machine behaves as if lid opened; continuity test fails on lid switch

Part: Lid switch / door lock assembly

Control board / timer electronics glitch

How to Identify: Cycle stops without other clear mechanical issues; resets may temporarily allow full cycles

Part: Main control board / timer

Preventive Maintenance

  • Regularly clean drain filter and hose: Drainage clogs that can stop cycles
    Frequency: monthly
  • Avoid overloading and balance laundry properly: Load imbalance related cycle stops
    Frequency: Every wash

Frequently Asked Questions

Why is my Maytag Washing Machine not completing cycle?
Common reasons include an unbalanced load or a faulty lid switch. These can cause the washer to stop mid-cycle.
How do I fix Maytag Washing Machine not completing cycle myself?
Currently, there are no DIY solutions available for this issue. It's best to consult a professional.
How much does it cost to fix not completing cycle?
Pricing for repairs can vary widely based on the issue. Consult a technician for an accurate estimate.
When should I call a technician for not completing cycle?
If the washer frequently stops mid-cycle or shows error codes, it's advisable to call a technician for further diagnosis.

References & Sources

Community Analytical Insights

Analysis based on real user discussions from appliance repair communities

Can I Fix This Myself?

50%
DIY Success Rate Difficulty: Either

Common Issues Reported by Users

  • Control board issues (3 mentions)
  • Water valve problems (2 mentions)
  • Lid lock malfunction (2 mentions)
  • Actuator failure (2 mentions)

User Suggested Solutions

  1. Recalibration of the washer

    Success rate: 20.0%

  2. Manual door lock release and cleaning filter

    Success rate: 20.0%
Analysis based on 5 community discussions
View Sources

Data compiled from real discussions on r/appliancerepair and r/Appliances:

  1. Maytag Washer MVWB765FC1 shuts off mid cycle
  2. Maytag front load washer stopped during cycle displays ERR a...
  3. Maytag Washer Not Rinsing or Completing Cycle
  4. Maytag washer sensing then stopping
  5. Repair Maytag washer/know issue?

Community Discussions

doesn't complete the cycle and winds up stuck on 'wash'

Recalibration may fix the issue; if not, check actuator or lid lock.

DIY View on Reddit →

stopped during cycle displays ERR and door won't unlock

Used manual door lock release to retrieve clothes; cleaning filter may be necessary.

DIY View on Reddit →

Source: Reddit r/appliancerepair

User Comments (0)

Share your experience or solution below.

Be the first to comment!