Maytag Washing Machine: leaking, shaking, clogging, damaging clothes

Professional Repair Guide

What is this symptom?

Experiencing issues with your Maytag washing machine? Common problems include leaking water, excessive shaking, clogs, and snagged clothes. These symptoms often stem from faulty hoses, unbalanced loads, or internal damage. Discover effective solutions to restore your washer's performance.

Urgency: Medium

Important Tips for Maytag Models

  • Maytag official troubleshooting highlights leaks from drain hoses and connections and provides step-by-step identification

Possible Causes

Water leak from hoses or connections

How to Identify: Visible water pooling under machine at hose connection points or during fill/drain cycles; loose or cracked hoses

Part: Inlet/Drain Hoses and Connections

Drain pump or internal seal failure

How to Identify: Leak from bottom of machine during or after drain cycle; error codes; water not fully draining

Part: Drain Pump / Seals

Washer vibration due to unbalanced load or suspension failure

How to Identify: Machine shakes violently during spin; uneven load; machine moves from position

Part: Shock Absorbers / Suspension Springs

Clogs in drain pump, filter, or hose

How to Identify: Slow or no draining, water backing up, error codes, wet floor

Part: Drain Pump / Filter / Hose

Interior drum/inner tub damage causing clothes snagging and tearing

How to Identify: Sharp edges inside drum; fabric catches when running hand over interior

Part: Drum / Inner Tub

DIY Solutions

Check and tighten hoses

Moderate 15-30 minutes
Tools Needed: wrench, bucket, towels
  1. Turn off water and unplug machine
  2. Inspect inlet and drain hoses for cracks and tightness
  3. Tighten loose connections and replace damaged hoses
⚠️ Safety First: Turn off power and water supply before work

Level the washing machine and balance loads

Easy 10 minutes
Tools Needed: level, adjustable wrench maybe
  1. Use a level to check machine position
  2. Adjust feet to level the washer
  3. Ensure laundry loads are balanced each cycle

Clear clogs in drain pump/filter

Moderate 30-60 minutes
Tools Needed: screwdriver, bucket, gloves
  1. Unplug machine and access drain pump filter
  2. Place bucket under filter area
  3. Remove debris and clear obstruction
⚠️ Safety First: Beware of residual water release

Next step

Choose the next step for leaking, shaking, clogging, damaging clothes

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Other parts options

Check related components first; use model search as a fallback.

Possible related component

Washer Shock Absorber

Dampens tub movement and vibration during high-speed spin cycles.

$25 - $100 · Medium · 45-90 mins

Check fit & price
Possible related component

Washer Tub Assembly

Forms the model-specific inner basket and outer water-containing tub assembly.

$150 - $600 · Hard · 120-240 mins

Check fit & price
Model number required

Model-compatible Washing Machine parts

Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.

Find a part that fits my model

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Optional routine care

Maintenance supplies

These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.

Maintenance supply

Washing Machine Cleaner Tablets

Routine tub-cleaning supplies for residue and odor control. They do not repair a mechanical, drainage, or electronic fault.

View maintenance supply
Maintenance supply

Braided Washer Inlet Hoses

A maintenance replacement option for visibly worn external fill hoses. Verify thread size, length, and hot/cold connection requirements.

View maintenance supply
Maintenance supply

Washer Drain Hose Holder

Helps secure an external drain hose at the standpipe. It does not correct an internal pump or control fault.

View maintenance supply

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.

Professional Repairs

Replace drain pump or internal seals

Estimated Cost: $80-$250

Replace shock absorbers or suspension springs

Estimated Cost: $60-$180 per part

Replace damaged drum or inner tub

Estimated Cost: $200-$600

When to Call a Professional

Water leaks persist after tightening hoses
Severe shaking after balancing and leveling
Clothes continue getting damaged after inspection
Clogs inside pump that cannot be reached

Preventive Maintenance

  • Regularly inspect hoses and connections: Leaks and hose failures
    Frequency: monthly
  • Level machine and avoid overloading: Vibration, shaking and potential wear
    Frequency: each use
  • Clean drain pump filter: Clogs and drainage issues
    Frequency: every 3 months

Frequently Asked Questions

Why is my Maytag Washing Machine leaking, shaking, clogging, damaging clothes?
Common causes include water leaks from hoses, unbalanced loads causing vibrations, clogs in the drain system, and damaged drum surfaces.
How do I fix Maytag Washing Machine leaking, shaking, clogging, damaging clothes myself?
Check and tighten hoses, level the washer, and clear clogs from the drain pump and filter for effective DIY repairs.
How much does it cost to fix leaking, shaking, clogging, damaging clothes?
Professional repairs can range from $60 for parts like shock absorbers to $600 for drum replacements.
When should I call a technician for leaking, shaking, clogging, damaging clothes?
Call a technician if DIY fixes don't resolve the issues, especially for complex repairs like pump or drum replacements.

References & Sources

Community Analytical Insights

Guidance from available sources; statistical claims are shown only for samples of at least 10 discussions

Common Issues Reported by Users

  • Worn or damaged door seal causing leaks
  • Unbalanced load leading to shaking
  • Clogged drain filter or hose causing water backup
  • Excessive detergent use leading to suds overflow
  • Damaged drum or agitator causing clothing damage

User Suggested Solutions

  1. Inspect and replace the door seal if damaged. Ensure the seal is clean and properly seated.

  2. Redistribute the load evenly in the drum. If necessary, adjust the leveling feet of the machine.

  3. Check and clean the drain filter and hose. Remove any obstructions that may be causing clogs.

  4. Reduce the amount of detergent used according to the manufacturer's guidelines to prevent suds overflow.

  5. Inspect the drum and agitator for damage. Replace any broken components to prevent clothing damage.

Limited-source guidance; percentages and success-rate claims are not shown
View Sources

Data compiled from real discussions on r/appliancerepair and r/Appliances:

  1. What washing machine do I buy?

Community Discussions

leaking from under the tub, shaking, clogging, eating clothes

Consider purchasing a new washing machine, possibly a Speed Queen or Maytag Commercial.

Source: Reddit r/appliancerepair

User Comments (0)

Share your experience or solution below.

Be the first to comment!

Call Local Repair Provider +1 (888) 217-6318