Fisher & Paykel Oven Error F2

⚡ Quick Answer: The Fisher & Paykel oven F2 error indicates an over-temperature condition detected by the temperature sensor, often resulting in erratic temperature r... ✅ DIY Fixable

What Does Error F2 Mean?

The Fisher & Paykel oven F2 error indicates an over-temperature condition detected by the temperature sensor, often resulting in erratic temperature readings, overheating, or the oven shutting down during use. This malfunction can occur during normal heating or self-cleaning cycles, and it may cause the oven to beep or stop heating altogether.

Common Symptoms:

  • Oven shuts down or displays F2 during heating or self‑clean/pyrloytic cycle
  • Temperature rising uncontrollably beyond the set point
  • Oven may beep or stop heating

Possible Causes

  • Over‑temperature condition detected by oven temperature sensor (medium)
  • Temperature sensor out of range or failing (medium)

How to Fix Error F2

DIY Fix Cool down and reset oven

  1. Turn off the oven and allow it to fully cool down.
  2. Once cool, open the oven door and wait additional time to ensure interior is not hot.
  3. Reconnect power or reset per user manual instructions.

Technician Only Check and test temperature sensor

  1. Disconnect power to the oven.
  2. Access and visually inspect the temperature sensor and its wiring harness.
  3. Measure sensor resistance with a multimeter (compare to expected OEM spec).
  4. Replace sensor if readings are outside control specifications.

Parts needed: Oven temperature sensor, Sensor wiring harness/connectors

Technician Only Inspect control electronics

  1. Check oven control board for damage or faults if sensor tests within range.
  2. Verify sensor data interpretation by controller.
  3. Replace control board if confirmed faulty per OEM diagnostic procedures.

Parts needed: Oven control board

🛑 When to Call a Pro:
  • If F2 reoccurs after basic cooling and reset
  • If you are uncomfortable accessing internal components
  • If temperature sensor testing or replacement does not resolve the error

Technical Specifications

wattage
component Temperature Sensor
resistance 1,000 ohms at room temperature
part_number BPX100
voltage_rating 240V AC

Common Questions

What does F2 error mean on Fisher & Paykel oven?

F2 error indicates an over-temperature condition caused by a malfunctioning temperature sensor.

Can I fix Fisher & Paykel oven F2 error myself?

Yes, you can try cooling down and resetting the oven. If the error persists, further inspection may be needed.

How much does it cost to fix F2 error?

Repair costs for the F2 error typically range from $50 to $200, depending on parts and labor.

When should I call a technician for F2?

Call a technician if the F2 error reoccurs after a reset or if you're uncomfortable accessing the internal components.

Data last verified: 2026-07-07

User Comments (0)

Share your experience or solution below.

Be the first to comment!