Electrolux Dishwasher Error iF0

⚡ Quick Answer: The Electrolux dishwasher error code iF0 indicates a drainage issue, typically caused by an overfill condition detected by the internal water level se... ✅ DIY Fixable

What Does Error iF0 Mean?

The Electrolux dishwasher error code iF0 indicates a drainage issue, typically caused by an overfill condition detected by the internal water level sensor. This error may result in the dishwasher displaying iF0 or iFo, unusual sounds from the pump, and a failure to complete wash cycles. To resolve this issue, ensure that the water supply tap is fully open and check for kinks in the inlet hose. If the problem persists, further inspection of the water level and pressure system may be required.

Common Symptoms:

  • Dishwasher displays iF0 (sometimes shown as iFo) and may stop operation
  • Possible overfill condition with continuous drain pump activity
  • Dishwasher may not start a cycle normally until resolved

Possible Causes

  • Water level problem / overfill detected by sensor (high)

How to Fix Error iF0

DIY Fix Basic checks and reset

  1. Turn off dishwasher and unplug (or switch off breaker) for ~1 minute
  2. Check that water supply tap is fully open and no other high-demand fixtures are using water simultaneously
  3. Inspect inlet hose for kinks or twists
  4. Clean dishwasher filters and sump of debris

Technician Only Inspect water level and pressure system

  1. Verify correct operation of water inlet valve and adequate supply pressure
  2. Check pressure sensor and pressure hose for blockages
  3. Test float switch or sensor circuits as per service manual
  4. Evaluate if drain pump is cycling excessively due to overfill detection
  5. Replace defective components as needed

Parts needed: pressure sensor, inlet valve, pressure hose, float assembly

🛑 When to Call a Pro:
  • If iF0 returns after basic checks and reset
  • If water leakage is observed or water repeatedly overfills
  • If user cannot safely access internal components

Technical Specifications

wattage 60W
component Drain Pump
resistance 10-30 ohms
part_number 154567401
voltage_rating 120V AC

Common Questions

What does iF0 error mean on electrolux dishwasher?

The iF0 error indicates a drainage issue, often due to an overfill condition detected by the water level sensor.

Can I fix electrolux dishwasher iF0 error myself?

Yes, you can perform basic checks by resetting the dishwasher and ensuring there are no kinks in the inlet hose.

How much does it cost to fix iF0 error?

Repair costs for the iF0 error typically range from $50 to $250, depending on parts and labor.

When should I call a technician for iF0?

Call a technician if the iF0 error returns after basic checks, if water leaks are observed, or if you cannot safely access internal components.

Sources & References

Data last verified: 2026-01-29

User Comments (0)

Share your experience or solution below.

Be the first to comment!