Whirlpool Refrigerator Error F1

⚡ Quick Answer: F1 means Whirlpool Refrigerator error F1 indicates a failure in the temperature sensor, which may cause the display to show incor... This is typically a DIY fix.

What Does Error F1 Mean?

Whirlpool Refrigerator error F1 indicates a failure in the temperature sensor, which may cause the display to show incorrect temperature readings and the unit to run continuously.

Common Causes

  • Temperature Sensor (60% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Temperature Sensor

    Locate the temperature sensor inside the refrigerator. It is usually found near the evaporator coil. Check for any visible damage or disconnection.

    Ensure the sensor is securely connected before testing.

  2. Step 2: Test the Sensor with a Multimeter

    Disconnect the sensor from the wiring harness and set your multimeter to the resistance (ohms) setting. Measure the resistance of the sensor; it should be within the manufacturer's specifications.

    Refer to the service manual for the correct resistance values.

  3. Step 3: Replace the Sensor if Necessary

    If the resistance is outside the specified range, replace the temperature sensor with a new one. Reconnect the wiring harness and ensure it is secure.

    Use a genuine replacement part for best results.

  4. Step 4: Test the Refrigerator

    Plug the refrigerator back in and monitor the temperature display for accuracy. Ensure the unit cycles properly.

    Allow 24 hours for the temperature to stabilize.

How to Reset

To reset the F1 error, unplug the refrigerator for 5 minutes, then plug it back in. Monitor the display for any reoccurring errors.

Technical Specifications

wattage
component Temperature Sensor
resistance 5-10 kΩ at room temperature
part_number W10316822
voltage_rating 120V AC

Frequently Asked Questions

Can I replace the temperature sensor myself?

Yes, replacing the temperature sensor is a manageable task for those with basic repair skills.

How much does a temperature sensor cost?

A replacement temperature sensor typically costs between $20 and $50, depending on the model.

What causes the F1 error in my Whirlpool refrigerator?

The F1 error is primarily caused by a malfunctioning temperature sensor, leading to incorrect temperature readings.

Should I call a professional if the F1 error persists?

Yes, if the error continues after replacing the sensor, it may indicate a deeper issue with the control board or wiring.

When should I expect the refrigerator to stabilize after fixing the F1 error?

You should allow up to 24 hours for the refrigerator to stabilize and display accurate temperatures after the repair.

User Comments (0)

Share your experience or solution below.

Be the first to comment!