Teco Dishwasher Error EE

⚡ Quick Answer: The TECO Dishwasher error code EE indicates a potential water leakage detection issue. This may be accompanied by continuous beeping and a flashing di... ✅ DIY Fixable

What Does Error EE Mean?

The TECO Dishwasher error code EE indicates a potential water leakage detection issue. This may be accompanied by continuous beeping and a flashing display. To address this error, ensure the dishwasher door is securely closed, check for any visible water leaks around the unit, and try power cycling the appliance by disconnecting it from the mains for a few minutes before reconnecting. If the problem persists, further diagnostics may be necessary.

Possible Causes

  • Water Level Sensor
  • Door Seal
  • Drain Pump Failure

How to Fix Error EE

DIY Fix Check basic dishwasher setup and clear error conditions

  1. Ensure the dishwasher door is fully and properly latched.
  2. Power cycle the dishwasher: disconnect it from mains for a few minutes and then reconnect.
  3. Check for any visible water leaks under the dishwasher or in access panels.
  4. Check that water supply and drainage hoses are securely connected and not blocked.

Technician Only Consult official TECO service documentation and diagnostics

  1. Obtain the official service manual for the specific TECO dishwasher model (e.g., TDW15WCG).
  2. Use diagnostic tools to read internal system logs or codes from the dishwasher control board.
  3. Inspect communication wiring between the control board and display module.
  4. Check control board and sensor modules for signs of wear or fault.
  5. Replace any failed components identified through testing.

Parts needed: Dishwasher control board, Display or user interface module, Internal communication harness

🛑 When to Call a Pro:
  • If the error persists after basic checks and power cycling.
  • If water leaks are present under the dishwasher base.
  • If the dishwasher fails to start or complete cycles with no clear cause.

Technical Specifications

wattage 1500W
component Water Level Sensor
resistance 5-15 ohms
part_number TECO-WLS-001
voltage_rating 240V AC

Common Questions

What does EE error mean on TECO Dishwasher?

EE error indicates a water leakage detection issue, often indicated by beeping and a flashing display.

Can I fix TECO Dishwasher EE error myself?

Yes, you can check the door latch, look for leaks, and power cycle the dishwasher.

How much does it cost to fix EE error?

Repair costs vary widely; control board replacements can typically exceed several hundred USD.

When should I call a technician for EE?

Call a technician if the error continues after DIY checks, if there are visible leaks, or if the dishwasher won't start.

Data last verified: 2026-07-01

User Comments (0)

Share your experience or solution below.

Be the first to comment!