Simpson Dryer Error E30
⚡ Quick Answer: The E30 error code on Simpson dryers indicates a potential malfunction, possibly involving the heating element or related components. This may result ... ✅ DIY Fixable
What Does Error E30 Mean?
The E30 error code on Simpson dryers indicates a potential malfunction, possibly involving the heating element or related components. This may result in the dryer failing to heat properly or unusual operational sounds. To troubleshoot, ensure the dryer is plugged in, the door is secure, and the lint filter is clean. If issues persist, further investigation by a professional may be necessary.
Possible Causes
- Heating Element
- Thermal Fuse
- Wiring Issues
How to Fix Error E30
DIY Fix Check basic operation and settings
- Ensure the dryer is properly plugged into a grounded electrical outlet and the power supply is stable.
- Confirm the dryer door/lid is fully closed and the safety interlock is engaged.
- Clean the lint filter before and after each load.
- Restart the dryer by unplugging for 5 minutes and then powering it back on.
Technician Only Professional diagnostic service
- Connect the dryer to diagnostic tools to read stored service codes if available.
- Check internal components including heating element, thermostats, and control board for wiring or faults.
- Inspect moisture sensors, temperature sensors, and interlock switches.
- Replace any failed components confirmed via testing.
Parts needed: Heating element, Thermostat/temperature sensors, Control board, Door interlock switch
- If the error persists after basic user reset attempts.
- If there are signs of electrical faults (smoke, burning smell).
- If the dryer intermittently stops during cycles or components feel excessively hot.
Next step
Choose the next step for E30
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Heating Element
Heats the water or air inside the appliance to the required temperature.
- Typical part-only price
- $40 - $95
- DIY difficulty
- Medium
- Estimated time
- 30-45 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Thermostat
Regulates temperature by turning the heating or cooling system on or off.
Main Control Board
The central brain of the appliance that controls all components, cycles, and timings.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | 5000W |
|---|---|
| component | Heating Element |
| resistance | 10-20 ohms |
| part_number | SIM-HEAT-001 |
| voltage_rating | 240V AC |
Common Questions
What does E30 error mean on Simpson dryer?
E30 indicates a potential malfunction, possibly with the heating element.
Can I fix Simpson dryer E30 error myself?
Yes, check power connection, door closure, and clean the lint filter.
How much does it cost to fix E30 error?
Repair costs typically range from $150 to $450, depending on parts and labor.
When should I call a technician for E30?
Call a technician if the error persists after troubleshooting or if you notice electrical faults.
Sources & References
- Simpson Australia Support & Troubleshooter (official)
- Condenser Dryer - E30 Error Help Center (other brand) (community)
Data last verified: 2026-04-23
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!