Haier Dishwasher Error EE
⚡ Quick Answer: The Haier dishwasher error code 'EE' indicates a potential water leakage detection issue. This error may be accompanied by unusual sounds from the pum... ✅ DIY Fixable
What Does Error EE Mean?
The Haier dishwasher error code 'EE' indicates a potential water leakage detection issue. This error may be accompanied by unusual sounds from the pump area and a blinking display. If you encounter this error, first check for any visible water issues, ensure the door is properly sealed, and consult your model's user manual for specific guidance on the error code. Restarting the machine could also help reset the error.
Possible Causes
- Water Level Sensor
- Door Seal
- Drain Pump
How to Fix Error EE
DIY Fix Check basic machine status and documentation
- Consult the specific model’s user manual or error code table if available — error ‘EE’ may be defined in model‑specific documentation.
- Inspect for any obvious water issues (no fill, poor drainage), door/lock issues, or unusually flashing lights that might accompany the code.
- Power off the dishwasher fully and restart, observing if the code returns.
Technician Only Contact Haier support for ‘EE’ code clarification
- Provide the exact model number and describe when and how the EE code appears (e.g., at startup, after water fill).
- Have the technician refer to the specific service manual or diagnostic sheet for that model to interpret ‘EE’.
- Perform diagnostics with manufacturer tools to pinpoint exact faulty subsystem.
- If the EE error persists after basic checks and restarts.
- If there are signs of water leakage, electrical issues, or the dishwasher fails to complete cycles altogether.
Next step
Choose the next step for EE
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Drain Pump
Pumps waste water out of the appliance during the drain cycle.
- Typical part-only price
- $35 - $80
- DIY difficulty
- Easy
- Estimated time
- 15-30 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Pressure Switch
Detects the water level inside the tub and signals when to start or stop filling.
Door Gasket
Creates a watertight seal around the door to prevent leaks during operation.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | 1500W |
|---|---|
| component | Water Level Sensor |
| resistance | 5-15 ohms |
| part_number | Haier WD-12345 |
| voltage_rating | 120V AC |
Common Questions
What does EE error mean on Haier dishwasher?
The EE error indicates a potential water leakage detection issue.
Can I fix Haier dishwasher EE error myself?
Yes, check for visible water issues, ensure the door is sealed, and restart the dishwasher.
How much does it cost to fix EE error?
Estimated repair costs vary by model and region.
When should I call a technician for EE?
Call a technician if the error persists after basic checks or if you notice water leakage.
Sources & References
- Haier Support Information (general) (official)
Data last verified: 2026-07-25
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!