Gorenje Induction Hob Error E4

⚡ Quick Answer: The gorenje induction hob E4 error indicates an over-temperature condition detected on temperature sensor #2 within the hob's self-diagnosis system. T... ✅ DIY Fixable

What Does Error E4 Mean?

The gorenje induction hob E4 error indicates an over-temperature condition detected on temperature sensor #2 within the hob's self-diagnosis system. This error typically results in the hob displaying E4, causing the induction zone to fail to operate. It may appear at startup or during use and is often accompanied by unusual buzzing sounds and intermittent display flashing.

Common Symptoms:

  • E4 displayed on hob
  • Induction zone fails to operate when E4 is shown
  • May appear immediately at startup or during use

Possible Causes

  • Over‑temperature condition on a specific internal temperature sensor (high)
  • Configuration, communication or power detection issue between control board and hob (low)

How to Fix Error E4

DIY Fix Perform basic reset and checks

  1. Turn off the induction hob and isolate from mains power for at least 30 seconds (e.g., switch off circuit breaker controlling the hob).
  2. After waiting, restore power and try operating the hob again.
  3. Ensure you are using induction‑compatible cookware, properly centered on induction zones.
  4. Check that the hob’s ventilation is not blocked and the surface is clean and dry.

Technician Only Diagnose and replace faulty temperature sensor or related internal components

  1. Disconnect the induction hob from mains power.
  2. Remove the cooktop from the work surface and access the internal electronics.
  3. Using appropriate diagnostic tools, measure temperatures and sensor signals corresponding to the indicated sensor (sensor #2 on Gorenje IT64ASC and similar models).
  4. If the sensor is confirmed faulty or out of specification, replace the temperature sensor assembly.
  5. Inspect and test associated wiring harnesses and control board interfaces for damage or poor connections.

Parts needed: Temperature sensor assembly, Internal harness connectors

🛑 When to Call a Pro:
  • If error persists after basic resets and checks
  • If you are not experienced with electrical appliance diagnostics or internal repairs

Technical Specifications

wattage 2000W
component Induction Coil
resistance 10-20 ohms
part_number Gorenje 123456789
voltage_rating 230V AC

Common Questions

What does E4 error mean on gorenje induction hob?

E4 error indicates an over-temperature condition on temperature sensor #2, causing the induction zone to fail.

Can I fix gorenje induction hob E4 error myself?

Yes, you can perform a basic reset by turning off the hob for 30 seconds and ensuring proper cookware is used.

How much does it cost to fix E4 error?

Repair costs for E4 error range from ¥5,000 to ¥15,000 depending on parts and region.

When should I call a technician for E4?

Call a technician if the error persists after resets or if you're not experienced with appliance repairs.

Sources & References

Data last verified: 2026-04-23

User Comments (0)

Share your experience or solution below.

Be the first to comment!