Ge Oven Error FC

⚡ Quick Answer: FC means ge oven error FC indicates a malfunctioning temperature sensor, often resulting in erratic temperature readings or failu... This is typically a DIY fix.

What Does Error FC Mean?

ge oven error FC indicates a malfunctioning temperature sensor, often resulting in erratic temperature readings or failure to heat.

Common Causes

  • Temperature Sensor (70% likelihood)
  • Wiring Issues (20% likelihood)
  • Control Board Malfunction (10% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Temperature Sensor

    Locate the temperature sensor inside the oven cavity. Check for visible damage or disconnection.

    Make sure to note the sensor's position for reinstallation.

  2. Step 2: Test the Sensor with a Multimeter

    Disconnect the sensor from the wiring harness. Set your multimeter to the resistance setting and measure the sensor's resistance. It should be around 1,000 ohms at room temperature.

    If the reading is significantly different, the sensor is faulty.

  3. Step 3: Check Wiring Connections

    Inspect the wiring harness for any signs of wear or damage. Ensure all connections are secure and free from corrosion.

    Repair any damaged wires before proceeding.

  4. Step 4: Replace the Temperature Sensor

    If the sensor is faulty, replace it with a new one. Reconnect the wiring harness and secure the sensor back in place.

    Ensure the new sensor is compatible with your oven model.

  5. Step 5: Test the Oven

    Turn on the oven and set it to a specific temperature. Monitor the oven to ensure it heats correctly and the error code does not reappear.

    If the error persists, consider checking the control board.

How to Reset

To reset the FC error, turn off the oven for 5 minutes and then turn it back on. If the error persists, further diagnosis is needed.

Technical Specifications

wattage N/A
component Temperature Sensor
resistance 1,000 ohms at room temperature
part_number WB21X5301
voltage_rating 120V AC

Frequently Asked Questions

Can I replace the temperature sensor myself?

Yes, replacing the temperature sensor is a straightforward process that most homeowners can handle with basic tools.

How much does it cost to replace the temperature sensor?

The cost of a replacement temperature sensor typically ranges from $20 to $50, depending on the model.

What causes the FC error in my GE oven?

The FC error is usually caused by a faulty temperature sensor, which can lead to incorrect temperature readings.

Should I call a professional if the error persists after replacing the sensor?

Yes, if the error continues, it may indicate a problem with the control board or wiring that requires professional attention.

When should I expect the FC error to clear after fixing?

The error should clear immediately after the faulty component is replaced and the oven is powered on again.

User Comments (0)

Share your experience or solution below.

Be the first to comment!