Ge Oven Error F3

⚡ Quick Answer: F3 means GE Oven error F3 indicates a malfunction in the oven temperature sensor, often resulting in erratic temperature readings... This is typically a DIY fix.

What Does Error F3 Mean?

GE Oven error F3 indicates a malfunction in the oven temperature sensor, often resulting in erratic temperature readings or the oven not heating properly.

Common Causes

  • Oven Temperature Sensor (70% likelihood)
  • Wiring Issues (20% likelihood)
  • Control Board Malfunction (10% likelihood)

Troubleshooting Steps

  1. Step 1: Test the Temperature Sensor

    Using a multimeter, check the resistance of the temperature sensor. It should read between 1000-1100 ohms at room temperature. If the reading is outside this range, the sensor is faulty.

    Ensure the multimeter is set to the correct resistance setting.

  2. Step 2: Inspect Wiring Connections

    Examine the wiring connecting the temperature sensor to the control board for any signs of damage or corrosion. Repair or replace any damaged wires.

    Use wire strippers to cleanly remove damaged sections.

  3. Step 3: Replace the Temperature Sensor

    If the sensor is faulty, remove the screws securing it in place and disconnect it from the wiring harness. Install the new sensor and secure it with screws.

    Ensure the new sensor is compatible with your GE oven model.

  4. Step 4: Test the Oven

    After replacing the sensor, turn on the oven to check if the error code has cleared and the oven heats properly.

    Monitor the oven for any unusual sounds or smells during the initial test.

How to Reset

The F3 error cannot be reset until the faulty temperature sensor is replaced. Once replaced, the error should clear automatically.

Technical Specifications

wattage
component Oven Temperature Sensor
resistance 1000-1100 ohms
part_number WB21X5301
voltage_rating 120V AC

Frequently Asked Questions

Can I replace the temperature sensor myself?

Yes, replacing the temperature sensor is a straightforward task that most homeowners can handle with basic tools.

How much does it cost to fix the F3 error?

The cost of a replacement temperature sensor typically ranges from $20 to $50, plus any additional tools if needed.

What causes the F3 error in GE ovens?

The F3 error is primarily caused by a faulty temperature sensor or issues with the wiring connecting it to the control board.

Should I call a professional if I see the F3 error?

If you're uncomfortable performing electrical repairs or if the error persists after replacing the sensor, it's best to consult a professional.

When should I expect the F3 error to clear?

The F3 error should clear immediately after the faulty temperature sensor is replaced and the oven is tested.

User Comments (0)

Share your experience or solution below.

Be the first to comment!