Amana Washing Machine: leaking
What is this symptom?
Is your Amana washing machine leaking water during filling, washing, or when idle? Common leak sources include loose hose connections, damaged hoses, or issues with the detergent dispenser. Identifying the leak's location can help you resolve the problem effectively.
Important Tips for Amana Models
- Official Amana guidance acknowledges washer leaks and suggests checking common issues including hoses and connections
Possible Causes
Loose or improperly seated water supply hose connections
How to Identify: Water dripping from where hoses connect to washer or wall during fill cycles
Part: Supply hoses and fittings
Damaged or worn water supply or drain hoses
How to Identify: Visible cracks, kinks, or water seepage along hose length or at hose ends; leaks often at bottom area of washer
Part: Water supply hose, drain hose
Clogged or overflowing detergent dispenser or internal overflow
How to Identify: Water leaking near top front or from dispenser area during wash cycles with excess suds
Part: Detergent dispenser, overflow tray
Internal tub seal or gasket failure
How to Identify: Leak appears from underneath machine or around door seal area during agitation or spin; consistent bottom leaks
Part: Inner tub seal, door gasket (if applicable)
Faulty drain pump or housing crack
How to Identify: Leak only during drain cycle, puddle near pump access panel at machine base
Part: Drain pump, pump housing
DIY Solutions
Tighten and inspect supply hose connections
- Turn off water supply
- Use wrench to gently tighten hose nuts at washer and wall
- Run a short fill cycle and observe for leaks
Replace damaged hoses
- Turn off water and unplug washer
- Remove old supply or drain hoses
- Install new hoses of correct size and tighten securely
- Restore water and test run
Clean detergent dispenser and reduce suds
- Remove dispenser drawer
- Rinse and clean with warm water
- Ensure correct detergent amount (HE if required)
- Replace and test
Check and adjust machine leveling
- Place level on machine top
- Adjust leg feet until level
- Retest operation to see if leak persists
Next step
Choose the next step for leaking
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Water Supply Hose
Connects your home water valves to the water inlet valve on the appliance.
- Typical part-only price
- $15 - $35
- DIY difficulty
- Easy
- Estimated time
- 10-15 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other parts options
Check related components first; use model search as a fallback.
Drain Hose
Carries waste water from the drain pump to your home's standpipe or sink drain.
Detergent Dispenser
Releases detergent, bleach, or rinse aid at the correct moment in the cycle.
Door Gasket
Creates a watertight seal around the door to prevent leaks during operation.
Model-compatible Washing Machine parts
Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Optional routine care
Maintenance supplies
These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.
Washing Machine Cleaner Tablets
Routine tub-cleaning supplies for residue and odor control. They do not repair a mechanical, drainage, or electronic fault.
Braided Washer Inlet Hoses
A maintenance replacement option for visibly worn external fill hoses. Verify thread size, length, and hot/cold connection requirements.
Washer Drain Hose Holder
Helps secure an external drain hose at the standpipe. It does not correct an internal pump or control fault.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.
Professional Repairs
Replace internal tub seal or gasket assembly
Replace drain pump or housing
When to Call a Professional
Preventive Maintenance
-
Inspect hoses and connections: Leaks due to hose wear or loosening
Frequency: every 6 months -
Clean detergent dispenser: Overflow and associated leaks
Frequency: monthly
Frequently Asked Questions
Why is my Amana Washing Machine leaking?
How do I fix Amana Washing Machine leaking myself?
How much does it cost to fix leaking?
When should I call a technician for leaking?
References & Sources
Community Analytical Insights
Guidance from available sources; statistical claims are shown only for samples of at least 10 discussions
Common Issues Reported by Users
- Leaking from the inlet valve (1 mentions)
- Leaking from the return seal (1 mentions)
- Leaking behind the drum after overfilling (1 mentions)
User Suggested Solutions
-
Replace the inlet valve
-
Replace the leaking part (W1089996)
-
Address the leak behind the drum
Limited-source guidance; percentages and success-rate claims are not shown
View
Sources
Data compiled from real discussions on r/appliancerepair and r/Appliances:
Community Discussions
leaking from return seal
Replace the leaking part (W1089996).
leaking from the bottom, rear side
The inlet valve is leaking at the coil valve.
leaking after being overfilled
The leak is behind the drum, not the pump or hoses.
washer leak
The center tub seal is suspected to be the cause of the leak, which is part of the transmission assembly.
Source: Reddit r/appliancerepair
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!