Amana Washing Machine: error codes

Professional Repair Guide

What is this symptom?

If your Amana washing machine is displaying error codes on its digital panel, it indicates potential issues like door lock failures, water supply problems, excessive suds, or sensor malfunctions. These alphanumeric codes help identify the specific faults affecting your appliance, allowing for targeted troubleshooting.

Urgency: Medium

Possible Causes

Control Lock Activated

How to Identify: Display shows LOC or LC error without impact on mechanical components; controls unresponsive until unlocked.

Part: Control panel/Lock feature

Excessive Suds

How to Identify: Display shows Sud or Sd; washer pauses to add water and rinse repeatedly.

Part: Detergent system / wash tub

Door Lock / Door Switch Failure

How to Identify: Codes like F5 E1/F5 E2 appear and washer won’t start or won’t unlock at end of cycle.

Part: Door lock assembly / switch

Preventive Maintenance

  • Use only HE detergent and proper amounts: Excessive suds and related error codes
    Frequency: Every wash cycle
  • Inspect and clean drain hose annually: Drain blockages and long drain errors
    Frequency: Annually

Frequently Asked Questions

Why is my Amana Washing Machine showing error codes?
Error codes indicate issues like control lock activation, excessive suds, or door lock failures.
How do I fix Amana Washing Machine error codes myself?
Currently, there are no DIY solutions available for these error codes.
How much does it cost to fix error codes?
Professional repair costs can vary; consult a technician for an accurate estimate.
When should I call a technician for error codes?
If error codes persist or you're unsure about the cause, it's best to call a technician.

References & Sources

Community Analytical Insights

Analysis based on real user discussions from appliance repair communities

Can I Fix This Myself?

75%
DIY Success Rate Difficulty: Either

Common Issues Reported by Users

  • Faulty door latch or door lock assembly
  • Malfunctioning control board or software issue
  • Blocked drain pump or hose

User Suggested Solutions

  1. Inspect the door latch for damage or misalignment. If faulty, replace the door latch assembly. Ensure that the door is securely closed during operation.

  2. Reset the washing machine by unplugging it for 5 minutes, then plug it back in. This can clear temporary software glitches.

  3. Check the drain pump and hose for clogs. Remove any debris or obstructions, and ensure the pump is functioning properly. Replace if necessary.

Analysis based on 1 community discussions
View Sources

Data compiled from real discussions on r/appliancerepair and r/Appliances:

  1. Need a washing machine, can't decide new or used, what to ge...

User Comments (0)

Share your experience or solution below.

Be the first to comment!