AEG Dishwasher Error i60

⚡ Quick Answer: The AEG dishwasher error code i60 indicates a heating or temperature-related fault, often resulting in the dishwasher not heating water during the was... ✅ DIY Fixable

What Does Error i60 Mean?

The AEG dishwasher error code i60 indicates a heating or temperature-related fault, often resulting in the dishwasher not heating water during the wash cycle. This error typically arises when the internal water temperature exceeds the recommended limit or when there’s a malfunction in the heating system, such as a faulty temperature sensor or heating element. Users may also notice unusual sounds from the pump during this issue.

Common Symptoms:

  • Dishwasher does not heat water
  • Error appears when heating phase should occur

Possible Causes

  • Water inlet temperature too high (high)
  • Internal heating system malfunction (temperature sensor or heating element) (medium)

How to Fix Error i60

DIY Fix Check water inlet temperature and reset

  1. Ensure water supply temperature at the dishwasher inlet does not exceed 60°C.
  2. Turn off the dishwasher and unplug or disconnect power for at least 30 seconds.
  3. Clean filters and sump area of foam/suds and debris as recommended by AEG.
  4. Reconnect power, select a suitable cycle and start to see if error clears.

Technician Only Inspect and possibly replace heating components

  1. Measure and verify temperature sensor and heating element functionality with appropriate tools.
  2. Check wiring integrity for heating system and sensor.
  3. Replace faulty temperature sensor or heating element if diagnostics confirm failure.

Parts needed: Temperature sensor (thermistor), Heating element

🛑 When to Call a Pro:
  • If basic resets and inlet checks do not clear the error
  • If heating elements or sensors show faults during diagnostics

Next step

Choose the next step for i60

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Based on diagnostic data

Most relevant component to inspect

Temperature Sensor

Monitors the internal temperature to ensure correct operation and prevent overheating.

Typical part-only price
$15 - $35
DIY difficulty
Easy
Estimated time
15-30 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Other components that may be involved

Check these only if your diagnosis points to them.

Possible related component

Heating Element

Heats the water or air inside the appliance to the required temperature.

$40 - $95 · Medium · 30-45 mins

Check fit & price

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage 60W
component Drain Pump
resistance 10-20 ohms
part_number AEG 124000000
voltage_rating 230V AC

Common Questions

What does i60 error mean on AEG dishwasher?

The i60 error indicates a heating issue, preventing the dishwasher from heating water during cycles.

Can I fix AEG dishwasher i60 error myself?

Yes, you can check the water inlet temperature and reset the dishwasher. Clean filters and debris as recommended.

How much does it cost to fix i60 error?

Repair costs for the i60 error typically range from $80 to $250, including parts and labor.

When should I call a technician for i60?

Call a technician if basic resets and checks do not resolve the error or if components show faults during diagnostics.

Sources & References

Data last verified: 2026-07-26

User Comments (0)

Share your experience or solution below.

Be the first to comment!