Whirlpool Dishwasher Error F11

⚡ Quick Answer: F11 means Whirlpool Dishwasher error F11 indicates a malfunction in the drain pump, often accompanied by unusual noises during ope... This is typically a DIY fix.

What Does Error F11 Mean?

Whirlpool Dishwasher error F11 indicates a malfunction in the drain pump, often accompanied by unusual noises during operation and failure to drain water.

Common Causes

  • Drain Pump (60% likelihood)
  • Control Board (30% likelihood)
  • Wiring Issues (10% likelihood)

Troubleshooting Steps

  1. Step 1: Check the Drain Filter

    Remove the bottom rack and check the drain filter for debris or foreign objects that may be obstructing the pump.

    Make sure to clean the filter thoroughly.

  2. Step 2: Inspect the Drain Pump

    Access the drain pump by removing the lower spray arm and the cover. Look for any visible damage or blockages.

    If the pump is clogged, clear it out carefully.

  3. Step 3: Test the Drain Pump with a Multimeter

    Disconnect the pump's wiring harness and use a multimeter to check for continuity. If there's no continuity, the pump needs replacement.

    Ensure the multimeter is set to the correct setting.

  4. Step 4: Examine Wiring Connections

    Inspect the wiring leading to the drain pump for any signs of wear or damage. Repair or replace any damaged wires.

    Secure all connections tightly.

  5. Step 5: Reassemble and Test the Dishwasher

    After making repairs, reassemble the dishwasher and run a short cycle to check if the error persists.

    Monitor for any unusual sounds during operation.

How to Reset

To reset the F11 error, hold the Start and Cancel buttons simultaneously for 3 seconds, then restart the dishwasher.

Technical Specifications

wattage 60W
component Drain Pump
resistance 10-30 ohms
part_number W10605057
voltage_rating 120V AC

Frequently Asked Questions

Can I fix the F11 error myself?

Yes, with basic tools and some troubleshooting skills, you can address the F11 error.

How long does it take to fix the F11 error?

Typically, it takes about 45-60 minutes to diagnose and fix the F11 error.

What causes the F11 error in my Whirlpool dishwasher?

The F11 error is usually caused by a malfunctioning drain pump or blockages in the drain system.

Should I call a professional for the F11 error?

If you're uncomfortable with electrical components or the issue persists after your repairs, it's best to call a professional.

When should I consider replacing the drain pump?

If the drain pump shows no continuity during testing or is visibly damaged, replacement is necessary.

User Comments (0)

Share your experience or solution below.

Be the first to comment!