Westinghouse Dishwasher Error iE0

⚡ Quick Answer: The iE0 error code on your Westinghouse Dishwasher typically indicates a malfunction in the drain pump, which may lead to unusual noises during operat... ✅ DIY Fixable

What Does Error iE0 Mean?

The iE0 error code on your Westinghouse Dishwasher typically indicates a malfunction in the drain pump, which may lead to unusual noises during operation and failure to drain water. To address this issue, confirm the error code against your specific model's user manual and attempt a basic reset by disconnecting the power for a few minutes. If the problem persists, further investigation or professional assistance may be necessary.

Possible Causes

  • Drain Pump

How to Fix Error iE0

DIY Fix Verify Code and Consult Manual

  1. Check your specific Westinghouse dishwasher model number and locate the official user manual for that model.
  2. Look for a section in the manual titled _Error Codes_ or _Failure Codes_ to confirm if iE0 is listed and what it means.
  3. If iE0 is not listed, the code may be model‑specific or not standardized across Westinghouse units.

DIY Fix Basic Reset Attempt

  1. Turn off the dishwasher and disconnect power (unplug or switch off the circuit breaker).
  2. Wait 5 minutes to allow the appliance’s electronics to reset.
  3. Reconnect power and restart a wash cycle to see if the error persists.

Technician Only Professional Diagnostic

  1. If the error persists and is not documented, have an authorised Westinghouse service technician inspect the unit.
  2. Technician may run service diagnostics to interpret iE0 and check wiring, sensors, and control board signals.
🛑 When to Call a Pro:
  • If the iE0 error code remains after a reset attempt.
  • If the dishwasher exhibits additional symptoms (leaks, failure to start, unusual noises).
  • If internal investigation beyond basic checks is required.

Next step

Choose the next step for iE0

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Check during diagnosis

Most relevant component to inspect

Drain Pump

Pumps waste water out of the appliance during the drain cycle.

Typical part-only price
$35 - $80
DIY difficulty
Easy
Estimated time
15-30 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Also check
RepairClinic

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage 50W
component Drain Pump
resistance 10-30 ohms
part_number WDW-123456
voltage_rating 120V AC

Common Questions

What does iE0 error mean on Westinghouse Dishwasher?

The iE0 error code indicates a drain pump malfunction, often resulting in failure to drain water.

Can I fix Westinghouse Dishwasher iE0 error myself?

Yes, you can verify the error code against your manual and attempt a basic reset.

How much does it cost to fix iE0 error?

Repair costs can vary depending on your region and service call fees.

When should I call a technician for iE0?

Call a technician if the error persists after a reset or if there are additional problems like leaks or unusual noises.

Data last verified: 2026-07-22

User Comments (0)

Share your experience or solution below.

Be the first to comment!