Westinghouse Dishwasher Error F1

⚡ Quick Answer: The F1 error code on your Westinghouse dishwasher indicates a water leakage detection issue, triggered by the internal flood sensor. This often result... ✅ DIY Fixable

What Does Error F1 Mean?

The F1 error code on your Westinghouse dishwasher indicates a water leakage detection issue, triggered by the internal flood sensor. This often results in a continuous beeping sound and may prevent the dishwasher from starting, with water pooling or moisture possibly found under the appliance. To resolve this, inspect for leaks, clear any blockages, and dry the base of the machine.

Common Symptoms:

  • F1 code displayed on control panel
  • Dishwasher will not start or continues to run drain pump
  • Possible water pooling or moisture under dishwasher

Possible Causes

  • Internal water leak detected by flood sensor (medium)
  • Clogged filter or drain causing water back‑up (medium)
  • Excess foam misread as leak (low)

How to Fix Error F1

DIY Fix Initial visual inspection and reset

  1. Turn off and unplug the dishwasher or switch off at breaker
  2. Pull dishwasher out and inspect underside/base for signs of water or moisture
  3. Dry any water present in base with towels or use absorbent materials
  4. Check bottom filter and drain openings for debris and clean

Technician Only Repair leaks and test sensors

  1. After visual inspection, locate source of leak (hose, connection, seal) and repair/replace faulty parts
  2. Test flood sensor operation and continuity with multimeter
  3. Verify drain system is clear and flow is proper
  4. Reassemble and test run cycle to confirm F1 error clears

Parts needed: flood sensor, door seal/gasket, drain hose or clamps, filters

🛑 When to Call a Pro:
  • Water continues to accumulate after drying and cleaning
  • Leak source cannot be identified
  • F1 persists after clearing water and normal drainage

Technical Specifications

wattage 1500W
component Leak Sensor
resistance 1-5 ohms
part_number WD-123456
voltage_rating 120V AC

Common Questions

What does F1 error mean on westinghouse dishwasher?

F1 error indicates a water leakage detection issue, often preventing the dishwasher from starting.

Can I fix westinghouse dishwasher F1 error myself?

Yes, you can perform a visual inspection and reset by drying any water under the dishwasher.

How much does it cost to fix F1 error?

Repair costs for the F1 error typically range from $100 to $300, depending on parts and labor.

When should I call a technician for F1?

Call a technician if water continues to accumulate or the leak source remains unidentified after cleaning.

Data last verified: 2026-03-09

User Comments (0)

Share your experience or solution below.

Be the first to comment!