Sub Zero Refrigerator Error 10-1-01

⚡ Quick Answer: The Sub Zero Refrigerator error 10-1-01 indicates a short circuit in the refrigerator cabinet thermistor, leading to inaccurate temperature readings. ... ⚠️ Difficulty Varies

What Does Error 10-1-01 Mean?

The Sub Zero Refrigerator error 10-1-01 indicates a short circuit in the refrigerator cabinet thermistor, leading to inaccurate temperature readings. This can cause the compressor to run continuously and may trigger a 'SERVICE' light or alarm. To resolve this issue, a thorough inspection of the thermistor and wiring harness is necessary.

Common Symptoms:

  • Error code 10‑1‑01 displayed on control panel
  • Refrigerator may not maintain temperature correctly
  • Possible ‘SERVICE’ light or alarm may accompany the code

Possible Causes

  • Refrigerator cabinet thermistor shorted (high)
  • Thermistor wiring harness fault (medium)

How to Fix Error 10-1-01

DIY Fix Basic Power Reset and Observation

  1. Turn off power to the unit at the circuit breaker for ~30 seconds then restore power.
  2. Observe if code reappears after restart.

Technician Only Thermistor and Wiring Inspection

  1. Access the refrigerator’s control panel and locate the refrigerator cabinet thermistor.
  2. Measure thermistor resistance with a multimeter to confirm a short (very low resistance) condition.
  3. Inspect wiring harness and connectors for signs of damage, burns, or shorts.
  4. Replace the thermistor and/or repair wiring as needed.

Parts needed: Refrigerator cabinet thermistor, Wiring harness/connectors

🛑 When to Call a Pro:
  • If the error persists after reset and basic inspection.
  • If multimeter testing cannot isolate the fault or if internal wiring damage is suspected.

Next step

Choose the next step for 10-1-01

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Based on diagnostic data

Most relevant component to inspect

Thermistor

Measures precise temperature changes and sends resistance feedback to the control board.

Typical part-only price
$15 - $35
DIY difficulty
Easy
Estimated time
15-30 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage
component Temperature Sensor
resistance 10-30 ohms
part_number Sub Zero 7011360
voltage_rating 120V AC

Common Questions

What does 10‑1‑01 error mean on Sub Zero Refrigerator?

It indicates a short circuit in the refrigerator's thermistor, causing incorrect temperature readings.

Can I fix Sub Zero Refrigerator 10‑1‑01 error myself?

Yes, you can try a power reset or basic inspection, but further diagnostics may require a technician.

How much does it cost to fix 10‑1‑01 error?

The estimated repair cost ranges from $50 to $250, including parts and technician labor.

When should I call a technician for 10‑1‑01?

Call a technician if the error persists after a reset or if you suspect wiring damage.

Sources & References

Data last verified: 2026-04-23

User Comments (0)

Share your experience or solution below.

Be the first to comment!