Smeg Washing Machine Error F13

⚡ Quick Answer: The Smeg Washing Machine error code F13 typically indicates a malfunction in the water level sensor. This issue may prevent the machine from filling o... ⚠️ Difficulty Varies

What Does Error F13 Mean?

The Smeg Washing Machine error code F13 typically indicates a malfunction in the water level sensor. This issue may prevent the machine from filling or draining properly, leading to operational failures. If this error occurs, it is essential to document the circumstances under which it appears and consider performing a basic reset to see if it resolves the issue.

Possible Causes

  • Water Level Sensor
  • Wiring Issues
  • Control Board Malfunction

How to Fix Error F13

DIY Fix Record context & contact Smeg support

  1. Note *exactly when* the F13 code appears (e.g., during fill, wash, drain, or spin).
  2. Take a photo of the display and any status lights at the same time.
  3. Locate your specific model number (often on the door frame or rear plate).
  4. Contact official Smeg customer support with the model and error details.

DIY Fix Basic reset attempt

  1. Turn off and unplug the machine from the power outlet.
  2. Wait at least 5 minutes to allow any residual charge to dissipate.
  3. Plug the machine back in and try restarting the cycle.

Technician Only Diagnose machine with model‑specific code reference

  1. Verify the exact Smeg model and check the official or workshop manual for error F13 definition.
  2. Observe when the code appears and correlate with operational phase.
  3. Inspect common fault areas for that model (sensors, water inlet, pressure switch, control board) guided by the specific definition.
🛑 When to Call a Pro:
  • If repeated reset attempts do not clear the code
  • If you are unsure of any troubleshooting step
  • If the machine displays additional fault behavior

Next step

Choose the next step for F13

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Check during diagnosis

Most relevant component to inspect

Pressure Switch

Detects the water level inside the tub and signals when to start or stop filling.

Typical part-only price
$25 - $65
DIY difficulty
Easy
Estimated time
15-30 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage N/A
component Water Level Sensor
resistance 5-10 ohms
part_number Smeg 610001123
voltage_rating 240V AC

Common Questions

What does F13 error mean on Smeg Washing Machine?

F13 indicates a malfunction in the water level sensor, affecting fill and drain functions.

Can I fix Smeg Washing Machine F13 error myself?

Yes, you can attempt a basic reset by unplugging the machine for 5 minutes and then restarting it.

How much does it cost to fix F13 error?

Repair costs vary depending on the model and region; contact a technician for an estimate.

When should I call a technician for F13?

Call a technician if resets do not resolve the issue or if additional faults occur.

Sources & References

Data last verified: 2026-07-22

User Comments (0)

Share your experience or solution below.

Be the first to comment!