Smeg Induction Hob Error ER16

⚡ Quick Answer: The SMEG induction hob error code ER16 indicates a malfunction related to the induction coil, often linked to an abnormal frequency in the pan detecti... ✅ DIY Fixable

What Does Error ER16 Mean?

The SMEG induction hob error code ER16 indicates a malfunction related to the induction coil, often linked to an abnormal frequency in the pan detection oscillators. This issue may cause the cooking zone to stop functioning and can be accompanied by unusual buzzing sounds and an unresponsive display. It's essential to ensure cookware is induction-compatible and properly placed before troubleshooting further.

Common Symptoms:

  • Induction hob displays ER16 on the control panel
  • Cooking zone stops functioning when the error appears

Possible Causes

  • Oscillator (pan detection) frequency abnormality during self‑diagnosis (low)

How to Fix Error ER16

DIY Fix Basic Checks and Power Reset

  1. Turn off the induction hob and disconnect it from mains power.
  2. Wait 5–10 minutes, then reconnect power and restart the hob.
  3. Ensure cookware is induction‑compatible, placed correctly, and the surface is clean.

Technician Only Service Diagnostic and Possible Oscillator/Control Inspection

  1. Use service tools to enter diagnostic mode and verify oscillator/pan detection frequency readings.
  2. Inspect and test pan detection circuitry and associated control board components.
  3. Replace faulty sensors or control board if diagnostics confirm hardware failure.

Parts needed: Pan detection sensor circuitry, Control board / electronic module

🛑 When to Call a Pro:
  • If ER16 persists after power reset and basic checks
  • If the hob fails to detect cookware normally after reset
  • If any unusual noises, smells, or overheating occur

Technical Specifications

wattage 3500W
component Induction Coil
resistance 10-30 ohms
part_number SMG-IC12345
voltage_rating 230V AC

Common Questions

What does ER16 error mean on SMEG induction hob?

ER16 indicates a malfunction in the induction coil, often linked to pan detection frequency issues.

Can I fix SMEG induction hob ER16 error myself?

Yes, try turning off the hob, disconnecting from power, and checking the cookware placement.

How much does it cost to fix ER16 error?

Repair costs range from ¥15,000 to ¥40,000+, depending on parts and region.

When should I call a technician for ER16?

Call a technician if the error persists after resets or if abnormal noises or overheating occur.

Sources & References

Data last verified: 2026-03-09

User Comments (0)

Share your experience or solution below.

Be the first to comment!