Smeg Induction Hob Error ER09

⚡ Quick Answer: The SMEG induction hob ER09 error code indicates a malfunction in the temperature sensor, leading to erratic display behavior or improper heating. If ... ✅ DIY Fixable

What Does Error ER09 Mean?

The SMEG induction hob ER09 error code indicates a malfunction in the temperature sensor, leading to erratic display behavior or improper heating. If you encounter this error, it may be due to incorrect cookware or a need for a reset. Regularly check that your cookware is induction-compatible and properly placed on the cooking zone. If issues persist, further diagnostics may be required.

Possible Causes

  • Temperature Sensor

How to Fix Error ER09

DIY Fix Verify documentation and model‑specific manual

  1. Locate the exact model number of your Smeg induction hob (e.g., SIMxxxx series).
  2. Check the user manual or official SMEG support site for that model’s error code list — as error codes vary by model and may not be published online.
  3. If you have a printed manual, review the troubleshooting section for ER09 or similar codes.

DIY Fix Basic reset & cookware check

  1. Switch off the hob at the mains supply (turn off the circuit breaker if needed).
  2. Wait at least 5–10 minutes to allow cooling and internal reset.
  3. Ensure that induction‑compatible cookware is being used and correctly positioned on the cooking zone.
  4. Switch the hob back on and observe if the error reappears.

Technician Only Contact SMEG technical support for ER09 diagnostic

  1. Provide the exact hob model and photographic evidence of the ER09 display.
  2. Request the official definition of ER09 for that specific induction hob model.
  3. Follow the guidance provided by SMEG support, which may include authorized service inspection.
🛑 When to Call a Pro:
  • If the error persists after power cycling and cookware verification.
  • If the hob exhibits additional faults (e.g., zones not heating, unusual noises, overheating).
  • If SMEG technical support confirms a component fault.

Next step

Choose the next step for ER09

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Check during diagnosis

Most relevant component to inspect

Temperature Sensor

Monitors the internal temperature to ensure correct operation and prevent overheating.

Typical part-only price
$15 - $35
DIY difficulty
Easy
Estimated time
15-30 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage 3000W
component Temperature Sensor
resistance 10-30 ohms
part_number SMEG TS12345
voltage_rating 230V AC

Common Questions

What does ER09 error mean on SMEG induction hob?

ER09 indicates a temperature sensor malfunction, leading to heating issues and erratic display.

Can I fix SMEG induction hob ER09 error myself?

Yes, verify your model's documentation, reset the hob, and ensure proper cookware is used.

How much does it cost to fix ER09 error?

Repair costs vary by model and region, so check with local technicians for estimates.

When should I call a technician for ER09?

Call a technician if the error persists after troubleshooting or if other faults arise.

Sources & References

Data last verified: 2026-07-25

User Comments (0)

Share your experience or solution below.

Be the first to comment!