Smeg Induction Hob Error ER08

⚡ Quick Answer: The SMEG induction hob error code ER08 indicates a malfunction within the induction coil, leading to an unresponsive cooking zone and no heat generati... ✅ DIY Fixable

What Does Error ER08 Mean?

The SMEG induction hob error code ER08 indicates a malfunction within the induction coil, leading to an unresponsive cooking zone and no heat generation. This issue may stem from an internal anomaly in the hob's control electronics, affecting its power-level detection. To troubleshoot, ensure your cookware is compatible and properly positioned, and check that the control surface is clean. If the error persists after basic checks, further inspection of the hob's electronics may be necessary.

Common Symptoms:

  • ER08 appears on the induction hob display during operation

Possible Causes

  • Internal control/state anomaly within hob electronics (community forum report) (low)

How to Fix Error ER08

DIY Fix Basic power and cookware checks

  1. Turn off the induction hob at the mains and wait 1–2 minutes, then restore power to see if the error clears.
  2. Ensure cookware used is induction‑compatible and correctly positioned on the cooking zone.
  3. Check that the control surface is clean and free of spills that might cause false inputs.

Technician Only Inspect control electronics and power‑level detection

  1. Access the hob’s internal control electronics and verify connections between the user interface and power control modules.
  2. Check for any software or firmware updates applicable to the hob model.
  3. Test the validity of control signals to the induction power circuits to ensure proper regulation of power levels.

Parts needed: Control board, User interface module

🛑 When to Call a Pro:
  • If ER08 persists after power cycling and basic checks
  • If the hob intermittently fails to heat or shows abnormal power behavior alongside ER08

Next step

Choose the next step for ER08

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Check during diagnosis

Most relevant component to inspect

Induction Heating Coil

Generates electromagnetic energy to heat pots and pans directly.

Typical part-only price
$80 - $180
DIY difficulty
Medium
Estimated time
30-60 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage 3500W
component Induction Coil
resistance 5-15 ohms
part_number SMEG-IC-12345
voltage_rating 230V AC

Common Questions

What does ER08 error mean on SMEG induction hob?

ER08 indicates a malfunction in the induction coil, causing no heat and an unresponsive cooking zone.

Can I fix SMEG induction hob ER08 error myself?

Yes, you can perform basic checks like power cycling and ensuring cookware compatibility.

How much does it cost to fix ER08 error?

Repair costs vary by model and region, including technician diagnostic fees and potential parts.

When should I call a technician for ER08?

Call a technician if the error persists after basic checks or if the hob shows abnormal heating behavior.

Sources & References

Data last verified: 2026-07-25

User Comments (0)

Share your experience or solution below.

Be the first to comment!