Ilve Dishwasher Error E13

⚡ Quick Answer: The Ilve dishwasher error code E13 signifies a malfunction with the temperature sensor (NTC), indicating that the water temperature during the cycle m... ✅ DIY Fixable

What Does Error E13 Mean?

The Ilve dishwasher error code E13 signifies a malfunction with the temperature sensor (NTC), indicating that the water temperature during the cycle may be excessively high or low. This can lead to the dishwasher stopping mid-cycle and displaying the error. If you hear unusual noises or experience improper draining, it may further confirm a fault with the temperature reading.

Common Symptoms:

  • Washer displays E13 during wash cycle
  • Dishwasher may stop mid‑cycle when temperature out of expected range

Possible Causes

  • Temperature sensor (NTC) malfunction or misreading (medium)
  • Excessive or incorrect inlet water temperature (medium)

How to Fix Error E13

DIY Fix Check water supply and restart

  1. Ensure dishwasher is supplied with cold water according to installation specifications.
  2. Turn off dishwasher and disconnect power for at least 5 minutes to allow electronic reset.
  3. Restart the dishwasher and observe if E13 reappears.

Technician Only Inspect and test temperature sensor circuitry

  1. Disconnect power and access the dishwasher’s internal temperature sensor (NTC).
  2. Test the NTC sensor with appropriate multimeter resistance values per model specifications to verify accuracy.
  3. Check wiring harness and connectors for damage or loose connections.
  4. Replace faulty NTC sensor if readings are out of expected range.

Parts needed: NTC temperature sensor, wiring harness/connectors

🛑 When to Call a Pro:
  • If repeated E13 errors appear after basic checks
  • If dishwasher overheats or unusual noises/steam occur
  • If sensor replacement attempts do not resolve error

Next step

Choose the next step for E13

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Based on diagnostic data

Most relevant component to inspect

Temperature Sensor

Monitors the internal temperature to ensure correct operation and prevent overheating.

Typical part-only price
$15 - $35
DIY difficulty
Easy
Estimated time
15-30 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage 50W
component Drain Pump
resistance 10-20 ohms
part_number ILVE-DP12345
voltage_rating 230V AC

Common Questions

What does E13 error mean on Ilve dishwasher?

E13 indicates a temperature sensor malfunction, affecting water temperature readings during the wash cycle.

Can I fix Ilve dishwasher E13 error myself?

Yes, you can check the water supply and perform a reset by disconnecting the power for 5 minutes.

How much does it cost to fix E13 error?

The estimated cost for parts to fix the E13 error ranges from $30 to $120, excluding labor.

When should I call a technician for E13?

Call a technician if E13 persists after basic checks or if you notice overheating or unusual noises.

Data last verified: 2026-04-23

User Comments (0)

Share your experience or solution below.

Be the first to comment!