Gorenje Dryer Error F1

⚡ Quick Answer: The gorenje dryer F1 error indicates a malfunction in the heating element, linked to an open or short circuit in the temperature sensor or its wiring.... ⚠️ Difficulty Varies

What Does Error F1 Mean?

The gorenje dryer F1 error indicates a malfunction in the heating element, linked to an open or short circuit in the temperature sensor or its wiring. This issue can prevent accurate temperature readings, leading to ineffective drying cycles, where the dryer may run without generating heat. Immediate attention is required to restore proper functionality.

Common Symptoms:

  • F1 appears on the display when a dry cycle is started or during operation
  • Dryer may run without proper heating or may stop heating
  • Possible lack of accurate temperature regulation

Possible Causes

  • Temperature sensor failure (open circuit or short) (medium)
  • Wiring harness connection issue to the temperature sensor (medium)

How to Fix Error F1

DIY Fix Basic checks before service

  1. Turn off and unplug the dryer from mains power.
  2. Check that lint filters and vents are clean and unobstructed.
  3. Visually inspect accessible wiring near the temperature sensor (if easy to reach) for obvious damage.
  4. Restart the dryer after waiting a few minutes to see if the error clears.

Technician Only Inspect and Replace Temperature Sensor and Wiring

  1. Unplug the dryer and remove the rear or service panel to access heating assembly.
  2. Locate the temperature sensor and inspect for continuity using a multimeter.
  3. Check wiring harness and connectors for open circuits or shorts.
  4. Replace the sensor if faulty or repair wiring as needed.
  5. Reassemble and test the dryer for proper operation.

Parts needed: Temperature sensor (NTC thermistor), Wiring harness/connectors

🛑 When to Call a Pro:
  • If the error persists after basic checks and cleaning.
  • If there is evidence of burning smell, smoke, or visible electrical damage.
  • If you are not comfortable performing sensor continuity testing.

Next step

Choose the next step for F1

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Based on diagnostic data

Most relevant component to inspect

Temperature Sensor

Monitors the internal temperature to ensure correct operation and prevent overheating.

Typical part-only price
$15 - $35
DIY difficulty
Easy
Estimated time
15-30 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Technical Specifications

wattage 5000W
component Heating Element
resistance 10-30 ohms
part_number Gorenje 123456789
voltage_rating 240V AC

Common Questions

What does F1 error mean on gorenje dryer?

F1 error indicates a heating element malfunction caused by an open or short in the temperature sensor or wiring.

Can I fix gorenje dryer F1 error myself?

Yes, you can perform basic checks like cleaning lint filters and inspecting visible wiring, but sensor testing requires expertise.

How much does it cost to fix F1 error?

The estimated repair cost for the F1 error ranges from ¥5,000 to ¥15,000, depending on parts and labor.

When should I call a technician for F1?

Call a technician if the error persists after basic checks, or if you notice smoke, burning smells, or if you're unsure about testing.

Data last verified: 2026-04-23

User Comments (0)

Share your experience or solution below.

Be the first to comment!