LG Refrigerator: not refrigerating
What is this symptom?
Is your LG refrigerator not refrigerating properly? You may notice that the internal fridge compartment fails to cool sufficiently, risking food spoilage. The freezer might also be affected, leading to inconsistent cooling. This issue can stem from common causes such as dirty condenser coils, fan motor failures, or door seal problems. Understanding these symptoms can help you take effective steps towards a solution.
Important Tips for LG Models
- In some LG models with inverter linear compressors, compressor failure is reported more commonly than older designs
Possible Causes
Dirty or obstructed condenser coils reducing heat dissipation
How to Identify: Visible dust/debris on condenser coils at back or bottom; fridge runs longer than normal and warms internally.
Part: Condenser coils
Evaporator or condenser fan motor failure
How to Identify: Freezer may be cold but fridge section warm; little or no airflow heard; fans do not spin.
Part: Evaporator or condenser fan motor
Compressor or start relay failure
How to Identify: Compressor not running or repeatedly clicking, fridge not cooling at all in both compartments.
Part: Compressor / start relay
Faulty damper control assembly limiting cold airflow
How to Identify: Freezer cold but refrigerator compartment stays warm despite normal operation; restricted airflow.
Part: Damper control assembly
Door gasket or seal issues allowing warm air infiltration
How to Identify: Visible gaps, torn seals, warm air leaks when door closed; condensation or frost near openings.
Part: Door gasket
DIY Solutions
Clean condenser coils
- Unplug refrigerator and pull it away from wall
- Locate coils (back or bottom beneath grille) and gently vacuum/brush off dust and debris
- Replace fridge and plug back in, monitor cooling over next 24 hours
Inspect and clear airflow vents and interior circulation
- Remove food blocking internal vents
- Rearrange items to allow free airflow
- Ensure fridge isn’t overpacked and vents within fridge aren’t blocked
Check door seals and clean/replace as needed
- Clean gasket with warm soapy water
- Inspect for tears or gaps
- Replace gasket if damaged
Unplug fridge briefly to reset control board
- Unplug refrigerator for 5–10 minutes
- Plug back in and allow appliance to stabilize
- Set desired temperatures and monitor cooling
Next step
Choose the next step for not refrigerating
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Condenser Coil Assembly
Releases heat from the refrigerant circuit and must match the appliance's sealed-system design.
- Typical part-only price
- $80 - $400
- DIY difficulty
- Hard
- Estimated time
- 120-240 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other parts options
Check related components first; use model search as a fallback.
Condenser Fan Motor
Moves air across the condenser and compressor compartment to remove heat.
Compressor
Compresses refrigerant within the sealed cooling system and requires specialized service equipment.
Refrigerator Damper Control Assembly
Regulates cold-air flow from the freezer into the refrigerator compartment.
Model-compatible Refrigerator parts
Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Optional routine care
Maintenance supplies
These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.
Refrigerator Condenser Coil Brush
For routine cleaning of accessible condenser areas where the manufacturer permits it. It does not repair a sealed-system or compressor fault.
Model-Compatible Refrigerator Water Filter
A routine replacement item on models with a water filter. Match the complete appliance model and existing filter number before ordering.
Compatibility check required: use the complete appliance model and compare the existing filter, bag, or specification before ordering.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.
Professional Repairs
Replace evaporator or condenser fan motor
Compressor or start relay replacement
Damper control assembly replacement
When to Call a Professional
Preventive Maintenance
-
Clean condenser coils: Heat dissipation issues and cooling inefficiency
Frequency: every 6 months -
Inspect door gaskets: Warm air infiltration and loss of cooling
Frequency: every 3 months
Frequently Asked Questions
Why is my LG Refrigerator not refrigerating?
How do I fix LG Refrigerator not refrigerating myself?
How much does it cost to fix not refrigerating?
When should I call a technician for not refrigerating?
References & Sources
Community Analytical Insights
Guidance from available sources; statistical claims are shown only for samples of at least 10 discussions
Common Issues Reported by Users
- Dirty condenser coils
- Faulty thermostat
- Blocked air vents
- Defective compressor
- Refrigerant leak
User Suggested Solutions
-
Unplug the refrigerator, locate the condenser coils, and clean them with a vacuum or brush. Ensure the area around the coils is clear of debris.
-
Check the thermostat settings to ensure it is set correctly. If it appears faulty, replace it by removing the cover and disconnecting the wires.
-
Inspect air vents inside the fridge and freezer for blockages. Remove any food items or ice buildup that may be obstructing airflow.
-
If the compressor is not running, check the start relay and overload protector. Replace if necessary, which may require a multimeter for testing.
-
If a refrigerant leak is suspected, contact a professional technician to locate and repair the leak and recharge the system.
Limited-source guidance; percentages and success-rate claims are not shown
View
Sources
Data compiled from real discussions on r/appliancerepair and r/Appliances:
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!