Arcelik Refrigerator: not cooling

Professional Repair Guide

What is this symptom?

Is your Arcelik refrigerator not cooling effectively? You may notice that despite the appliance running, the internal temperature remains warm, leading to spoiled food. Common causes include fan motor failures, dirty condenser coils, or door gasket issues. Understanding these problems can help you take the right steps to restore proper cooling.

Urgency: High

Important Tips for Arcelik Models

  • Arcelik official troubleshooting highlights door gasket issues and recommends service appointment if basic checks don’t resolve problem.

Possible Causes

Evaporator or condenser fan motor failure (air circulation issue)

How to Identify: Freezer may be cold but refrigerator section is warm; unusual noises; no airflow when door opens.

Part: Evaporator fan / condenser fan

Dirty condenser coils reducing heat dissipation

How to Identify: Back/bottom coils visibly dusty, refrigerator runs constantly but cannot maintain cold.

Part: Condenser coils

Door gasket seal failure allowing cold air escape

How to Identify: Cold air visibly escaping around door, easy pull test with paper reveals loose seal.

Part: Door gasket

Thermostat set incorrectly or faulty

How to Identify: Temperature dial setting not at recommended cooling level; clicking absent when adjusting.

Part: Thermostat

Compressor or start relay malfunction

How to Identify: Compressor warm but not running properly; clicking sounds; fridge does not cool after other issues ruled out.

Part: Compressor / start relay

Blocked internal air vents (airflow obstruction)

How to Identify: Items blocking airflow paths; fridge section warm despite freezer cold.

Part: Internal air vents

DIY Solutions

Clean condenser coils

Moderate 30–60 minutes
Tools Needed: vacuum with brush attachment, coil cleaning brush
  1. Unplug refrigerator.
  2. Locate condenser coils on back or beneath fridge.
  3. Use brush/vacuum to remove dust and debris from coils.
  4. Plug fridge back in and monitor cooling performance.
⚠️ Safety First: Disconnect power before cleaning.

Check and adjust thermostat settings

Easy 5–10 minutes
  1. Locate thermostat dial inside fridge.
  2. Ensure temperature is set to recommended cold level.
  3. Listen for clicking when adjusting; absence may indicate fault.

Inspect and rearrange internal items to improve airflow

Easy 5–15 minutes
  1. Remove items blocking vents inside fridge and freezer.
  2. Ensure airflow pathways are clear.
  3. Close door and observe temperature over time.

Check door gasket seal

Moderate 10–20 minutes
Tools Needed: small piece of paper
  1. Close fridge door on paper.
  2. Try pulling paper; easy pull indicates poor seal.
  3. Clean gasket or replace if damaged.

Next step

Choose the next step for not cooling

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Check during diagnosis

Most relevant component to inspect

Condenser Fan Motor

Moves air across the condenser and compressor compartment to remove heat.

Typical part-only price
$35 - $100
DIY difficulty
Medium
Estimated time
30-60 mins
Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Other parts options

Check related components first; use model search as a fallback.

Possible related component

Door Gasket

Creates a watertight seal around the door to prevent leaks during operation.

$45 - $110 · Medium · 30-60 mins

Check fit & price
Possible related component

Thermostat

Regulates temperature by turning the heating or cooling system on or off.

$15 - $40 · Easy · 15-30 mins

Check fit & price
Possible related component

Compressor

Compresses refrigerant within the sealed cooling system and requires specialized service equipment.

$180 - $600 · Hard · 120-240 mins

Check fit & price
Model number required

Model-compatible Refrigerator parts

Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.

Find a part that fits my model

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Optional routine care

Maintenance supplies

These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.

Maintenance supply

Refrigerator Condenser Coil Brush

For routine cleaning of accessible condenser areas where the manufacturer permits it. It does not repair a sealed-system or compressor fault.

View maintenance supply
Maintenance supply

Model-Compatible Refrigerator Water Filter

A routine replacement item on models with a water filter. Match the complete appliance model and existing filter number before ordering.

Compatibility check required: use the complete appliance model and compare the existing filter, bag, or specification before ordering.

Find one that fits my model

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.

Professional Repairs

Replace evaporator/condenser fan motor

Estimated Cost: $50 - $200

Compressor or sealed system repair

Estimated Cost: $300 - $700+

When to Call a Professional

No improvement after DIY steps and internal fan or compressor suspected
Signs of refrigerant leak (hissing, oil residue)
Compressor not running or starts then stops repeatedly

Preventive Maintenance

  • Clean condenser coils: Cooling inefficiency due to dust buildup
    Frequency: every 6–12 months
  • Check door gasket seals: Cold air leakage reducing cooling performance
    Frequency: annually

Frequently Asked Questions

Why is my Arcelik Refrigerator not cooling?
Common causes include fan motor failure, dirty condenser coils, or a faulty thermostat.
How do I fix Arcelik Refrigerator not cooling myself?
Try cleaning the condenser coils, adjusting the thermostat, or checking the door gasket for proper sealing.
How much does it cost to fix not cooling?
Professional repairs can range from $50 to $700+, depending on the issue.
When should I call a technician for not cooling?
If DIY fixes don't work or if there's a potential compressor issue, contact a technician immediately.

References & Sources

Community Analytical Insights

Guidance from available sources; statistical claims are shown only for samples of at least 10 discussions

Common Issues Reported by Users

  • Dirty condenser coils
  • Faulty thermostat
  • Blocked air vents

User Suggested Solutions

  1. Clean the condenser coils. Unplug the refrigerator, locate the coils (usually at the back or bottom), and use a vacuum or brush to remove dust and debris. Plug the refrigerator back in and check if cooling resumes.

  2. Check and replace the thermostat if necessary. Locate the thermostat inside the fridge, set it to a lower temperature, and listen for a click. If there’s no click, the thermostat may need replacing.

  3. Inspect and clear any blocked air vents. Ensure that there are no items obstructing the vents inside the fridge and freezer compartments to allow proper airflow.

Limited-source guidance; percentages and success-rate claims are not shown
View Sources

Data compiled from real discussions on r/appliancerepair and r/Appliances:

  1. Fridge is not cooling

User Comments (0)

Share your experience or solution below.

Be the first to comment!