Fisher & Paykel Dishwasher Error F8

⚡ Quick Answer: The Fisher & Paykel dishwasher F8 error indicates an electronic or circuit fault within the control system, manifesting as a drain pump failure. Users... ✅ DIY Fixable

What Does Error F8 Mean?

The Fisher & Paykel dishwasher F8 error indicates an electronic or circuit fault within the control system, manifesting as a drain pump failure. Users may notice that the dishwasher displays the F8 code, fails to start cycles, or stops unexpectedly. Unusual noises during operation may also be present, along with continuous beeping or unresponsiveness to user inputs.

Common Symptoms:

  • Dishwasher displays "F8" on control panel
  • Cycle may fail to start or stops unexpectedly
  • Dishwasher may beep continuously or not respond to inputs

Possible Causes

  • Electronic control or circuit fault (medium)

How to Fix Error F8

DIY Fix Basic reset and power check

  1. Turn off the dishwasher and disconnect it from the power supply (unplug or switch off at circuit breaker).
  2. Wait a few minutes to allow internal electronics to discharge.
  3. Restore power and attempt to run a cycle again to see if the F8 code clears.

Technician Only Inspect electronics and control board

  1. Disconnect power and pull out the dishwasher to access the control board safely.
  2. Visually inspect wiring harness connectors for loose connections, corrosion or damage.
  3. Test the main control board and associated electronics for faults and replace if defective.

Parts needed: Main control board, Wiring harness connectors

🛑 When to Call a Pro:
  • If the error persists after a reset and basic checks, or if there are signs of electrical damage or no user‑accessible reset clears the fault

Technical Specifications

wattage 50W
component Drain Pump
resistance 10-30 ohms
part_number FP-DW-PUMP-001
voltage_rating 240V AC

Common Questions

What does F8 error mean on fisher & paykel dishwasher?

The F8 error indicates an electronic fault related to the drain pump, causing the dishwasher to stop or not respond.

Can I fix fisher & paykel dishwasher F8 error myself?

Yes, try a basic reset by powering off the dishwasher for 5–10 minutes and then restoring power.

How much does it cost to fix F8 error?

Repair costs for the F8 error typically range from $150 to $500+, depending on parts and labor.

When should I call a technician for F8?

Call a technician if the error persists after a reset or if you notice signs of electrical damage.

Data last verified: 2026-03-13

User Comments (0)

Share your experience or solution below.

Be the first to comment!