Fisher & Paykel Dishwasher Error F11
⚡ Quick Answer: The F11 error code on your Fisher & Paykel dishwasher typically indicates a malfunction in the drain pump, which may lead to unusual noises or an inab... ✅ DIY Fixable
What Does Error F11 Mean?
The F11 error code on your Fisher & Paykel dishwasher typically indicates a malfunction in the drain pump, which may lead to unusual noises or an inability to drain water effectively. If this error persists, it is advised to perform a basic reset of the unit. If the issue continues after the reset, contacting a professional technician for further diagnosis is recommended.
Common Symptoms:
- Display shows F11 error code (specific symptoms not documented in available sources)
Possible Causes
- Drain Pump Assembly
- Wiring Issues
- Control Board Failure
How to Fix Error F11
DIY Fix Basic reset and check
- Stop the dishwasher beeping by pressing the stop/cancel button.
- Turn off the dishwasher.
- Wait a few seconds and turn the dishwasher back on to see if the F11 clears.
Technician Only Professional diagnosis for unrecognized F11 code
- Inspect dishwasher’s error memory with service diagnostic tools.
- Check electrical connections, water supply and drainage as part of deeper fault analysis.
- Identify and replace any failed sensors or control modules associated with the fault if documented by service manual.
Parts needed: Diagnostic interface/cable, Potential sensors (depending on diagnosis), Control board (if confirmed malfunctioning)
- F11 persists after reset
- Dishwasher will not complete cycle
- Leaks, unusual noises, or failure to fill/drain properly
Next step
Choose the next step for F11
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Main Control Board
The central brain of the appliance that controls all components, cycles, and timings.
- Typical part-only price
- $120 - $280
- DIY difficulty
- Medium
- Estimated time
- 20-40 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | 50W |
|---|---|
| component | Drain Pump Assembly |
| resistance | 10-20 ohms |
| part_number | FP-DW-PUMP-001 |
| voltage_rating | 240V AC |
Common Questions
What does F11 error mean on fisher & paykel dishwasher?
F11 error indicates a malfunction in the drain pump, causing drainage issues.
Can I fix fisher & paykel dishwasher F11 error myself?
Yes, you can try resetting the dishwasher by pressing the stop/cancel button, turning it off, and then back on.
How much does it cost to fix F11 error?
Repair costs for the F11 error typically range from $100 to $400, depending on local service rates and parts needed.
When should I call a technician for F11?
Call a technician if the F11 error persists after a reset, or if the dishwasher shows leaks, unusual noises, or fails to complete cycles.
Sources & References
- DishDrawer™ 'F' Fault Codes - Fisher & Paykel (official)
- DishDrawer™ 'F' Fault Codes (AU support) (official)
Data last verified: 2026-07-25
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!