Electrolux Oven Error F10

DIY Fix Power reset and basic checks

1. Turn off the oven and disconnect power (unplug or breaker) for ~30 seconds.
2. Restore power and see if F10 clears.
3. Ensure adequate ventilation around oven vents and check for obvious physical wiring damage visible without dismantling.

Technician Only Diagnose and replace faulty temperature sensor

1. Disconnect power and access the oven cavity rear or sensor mounting.
2. Measure sensor resistance at room temperature with a multimeter (expected ~1100 ohms).
3. Replace the oven temperature sensor if resistance is out of spec.
4. Reassemble and test the oven to confirm resolution.

Parts needed: Oven temperature sensor (RTD)

Technician Only Inspect control board and relays

1. After sensor test, inspect the electronic control board for damaged components or stuck relays.
2. Test relays for correct operation and replace if necessary.
3. Replace the electronic control board if sensor and wiring are good and error persists.

Parts needed: Electronic control board, Relays (if separate)