Breville Juicer Error E07

DIY Fix Basic checks when E07 appears

1. Ensure all parts are **correctly assembled and safety locking arm is engaged** — misalignment can trigger generic error codes.
2. Unplug the juicer and **clean all juicing parts** (filter basket, chute, blades) to remove pulp blockages.
3. Check the power supply: plug into a known working outlet and inspect the power cord for damage.
4. Allow the juicer to **cool down** if it has been running and may have overheated.
5. After performing the above, plug back in and power on to see if error clears.

Technician Only Service evaluation if E07 persists

1. Perform diagnostic to inspect internal safety switches and sensor alignment — unaligned or faulty safety interlocks can generate errors.
2. Check motor and control board connections for loose wiring or damaged components.
3. If available, use Breville service tools to test internal motor overload protection and temperature sensors.
4. If fault is internal, replace damaged parts and re-test operation.

Parts needed: Safety switch assemblies, Control board or sensor connections, Motor or wiring harness