Beko Dryer Error 10

⚡ Quick Answer: The Beko dryer error code 10 indicates a potential malfunction in the heating element or an issue with the mains supply voltage, which may exceed 265 ... ✅ DIY Fixable

What Does Error 10 Mean?

The Beko dryer error code 10 indicates a potential malfunction in the heating element or an issue with the mains supply voltage, which may exceed 265 V. This can prevent the dryer from producing heat and may cause the program to halt or not start at all. To resolve this issue, check the electrical supply and consider a basic reset of the appliance.

Common Symptoms:

  • Dryer displays error code 10 and may stop or halt operation
  • Program may not start or complete

Possible Causes

  • Mains supply voltage too high (>265 V) (medium)
  • Temperature sensor (NTC) or related sensor fault (low)

How to Fix Error 10

DIY Fix Check electrical supply and basic reset

  1. Ensure the dryer is connected to a properly rated mains outlet.
  2. Verify that household voltage is within the acceptable range (typically ~230 V AC).
  3. Power off the dryer, disconnect from the mains for 5–10 minutes, then reconnect and restart to see if the code clears.

Technician Only Inspect voltage supply and sensor circuitry

  1. Measure the incoming supply voltage at the appliance terminal to confirm whether it exceeds safe limits.
  2. If voltage irregularities are present, correct household wiring or install appropriate surge/protection devices.
  3. If supply voltage is correct, test temperature sensors (NTC) and their wiring for continuity and correct resistance values.
  4. Inspect control board connections related to sensors.

Parts needed: Multimeter for electrical checks, Temperature (NTC) sensor(s), Connector harnesses

🛑 When to Call a Pro:
  • If voltage is outside normal household range or internal components (sensors) appear damaged
  • If error persists after basic reset and safe household checks

Technical Specifications

wattage 3000W
component Heating Element
resistance 10-20 ohms
part_number Beko 280004000
voltage_rating 240V AC

Common Questions

What does 10 error mean on beko dryer?

Error 10 indicates a malfunction in the heating element or high mains supply voltage.

Can I fix beko dryer 10 error myself?

Yes, check the electrical supply and perform a basic reset by disconnecting the dryer for 5-10 minutes.

How much does it cost to fix 10 error?

Repair costs range from ¥5,000 to ¥25,000+, depending on parts and labor.

When should I call a technician for 10?

Call a technician if voltage is outside normal range or if internal components appear damaged.

Data last verified: 2026-01-14

User Comments (0)

Share your experience or solution below.

Be the first to comment!