AEG Dryer Error E60
⚡ Quick Answer: The AEG Dryer E60 error code indicates a heating system fault within the heat pump or heating circuit. This malfunction prevents the dryer from produc... ✅ DIY Fixable
What Does Error E60 Mean?
The AEG Dryer E60 error code indicates a heating system fault within the heat pump or heating circuit. This malfunction prevents the dryer from producing heat, resulting in cold air being blown during operation and wet laundry after the drying cycle. Common symptoms include the display of the E60 code, ineffective drying performance, and laundry remaining damp.
Common Symptoms:
- Dryer displays E60 on the control panel
- Dryer fails to heat or produces only cold air
- Laundry remains wet after cycle
- Drying performance is poor or incomplete
Possible Causes
- Heating circuit/heat pump malfunction (high)
How to Fix Error E60
DIY Fix Check ventilation and filters
- Ensure the dryer has adequate space around it and ventilation slots are unblocked
- Clean lint filter after every cycle
- Clean condenser and heat exchanger per manual instructions
DIY Fix Basic restart and environment check
- Unplug the dryer from mains for ~30 seconds, then plug back in
- Position the dryer in a well‑ventilated room with ambient temperature within recommended range
Technician Only Inspect and repair heating components
- Disconnect power and open dryer cabinet
- Test heater element and heat pump components for continuity/failure
- Check temperature sensors/thermostats and replace if faulty
- Inspect wiring and connections in heating circuit
Parts needed: Heating element/heat pump assembly, Temperature sensors/thermostats, Wiring harness
- If after cleaning and ventilation checks the dryer still does not heat after ~30 minutes of operation
- If internal diagnostics point to heating element/sensor failure
Next step
Choose the next step for E60
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Heating Element
Heats the water or air inside the appliance to the required temperature.
- Typical part-only price
- $40 - $95
- DIY difficulty
- Medium
- Estimated time
- 30-45 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Temperature Sensor
Monitors the internal temperature to ensure correct operation and prevent overheating.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | 2000W |
|---|---|
| component | Heating Element |
| resistance | 10-30 ohms |
| part_number | AEG 124000000 |
| voltage_rating | 230V AC |
Common Questions
What does E60 error mean on AEG Dryer?
E60 indicates a heating system fault, causing the dryer to blow cold air and fail to dry laundry.
Can I fix AEG Dryer E60 error myself?
Yes, check ventilation, clean filters, and restart the dryer. If issues persist, professional help may be needed.
How much does it cost to fix E60 error?
Repair costs range from $100 to $400, depending on parts and labor in your region.
When should I call a technician for E60?
Call a technician if the dryer still doesn't heat after 30 minutes of troubleshooting or if diagnostics indicate a component failure.
Sources & References
Data last verified: 2026-07-26
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!