AEG Dryer Error E30
⚡ Quick Answer: The AEG dryer error E30 indicates a water leak detection issue, triggering the anti-flood system. This malfunction prevents the dryer from starting or... ✅ DIY Fixable
What Does Error E30 Mean?
The AEG dryer error E30 indicates a water leak detection issue, triggering the anti-flood system. This malfunction prevents the dryer from starting or completing cycles, often accompanied by a beeping alarm. Users may find water present in the base tray, signaling the need for immediate attention to avoid further damage.
Common Symptoms:
- Dryer will not start or stops during a cycle while displaying E30.
- Beeping alarm may accompany the E30 code.
- Water present in the base tray or bottom of the dryer.
Possible Causes
- Leak detection / anti‑flood system triggered by water in the base tray (medium)
How to Fix Error E30
DIY Fix Check for water and clear base tray
- Unplug the dryer from power.
- Inspect the bottom/base tray for any accumulated water.
- Use towels or a small container to remove water from the tray.
- Ensure the area under the dryer is dry before powering on again.
Technician Only Locate and repair the source of leakage
- Disconnect the dryer from power and water (if applicable).
- Remove access panels to inspect hoses, seals, and connections for leaks.
- Check the condensate pump, hoses, door seal, and any water paths for cracks or looseness.
- Replace or reseal leaking components.
- Test by running a short cycle while observing for leaks before reassembling fully.
Parts needed: Hose clamps, Seals/gaskets, Condensate pump or drainage components (model dependent)
- If water source cannot be found or leak recurs after drying base tray.
- If internal components (hoses, seals, pump) show damage or require professional tools to access.
- If error persists after removing standing water and checking obvious leak points.
Next step
Choose the next step for E30
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Browse by model — no specific failed part is claimed
Model-compatible Dryer parts
Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Search results are not a diagnosis. Verify both the complete appliance model and the retailer's fit information before ordering.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Optional routine care
Maintenance supplies
These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.
Dryer Vent Cleaning Kit
Helps remove routine lint buildup from an accessible dryer vent path. It does not diagnose or repair an E-code or failed component.
Lint Trap Cleaning Brush
A narrow brush for routine cleaning around an accessible lint screen and housing.
Dryer Vent Hose Kit
A replacement exhaust duct option for visibly crushed or damaged external venting. Check diameter, length, local code, and installation clearance.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.
Technical Specifications
| note | The previous model-independent part specification was removed. Verify the full model number and diagnosis in the manufacturer's official parts catalog before ordering. |
|---|---|
| part_number | None |
Common Questions
What does E30 error mean on AEG dryer?
E30 error indicates a leak detection issue, preventing the dryer from starting due to water in the base tray.
Can I fix AEG dryer E30 error myself?
Yes, you can check for water in the base tray and remove it after unplugging the dryer.
How much does it cost to fix E30 error?
Repair costs can vary; minor seals range from $20–$80, while pumps or hoses may cost $50–$200+.
When should I call a technician for E30?
Call a technician if the source of the leak cannot be found or if the error persists after checking for water.
Data last verified: 2026-07-31
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!