Whirlpool Washing Machine Error Ld

⚡ Quick Answer: Ld means whirlpool washing machine error Ld indicates a drainage issue, often accompanied by a loud gurgling sound and the machin... This is typically a DIY fix.

What Does Error Ld Mean?

whirlpool washing machine error Ld indicates a drainage issue, often accompanied by a loud gurgling sound and the machine failing to complete cycles.

Common Causes

  • Clogged drain filter (50% likelihood)
  • Faulty drain pump (30% likelihood)
  • Kinked drain hose (20% likelihood)

Troubleshooting Steps

  1. Step 1: Check the drain filter for debris

    Locate the drain filter, usually at the front bottom of the machine. Open the cover and use a bucket to catch any water that may spill out. Remove the filter and clean it thoroughly to remove any lint or foreign objects.

    Pro tip: Always keep a towel handy to soak up any water.

  2. Step 2: Inspect the drain hose for kinks

    Trace the drain hose from the back of the washer to the drain. Ensure it is not kinked or pinched, as this can prevent proper drainage. Adjust the hose if necessary.

    Make sure the hose is not submerged in water.

  3. Step 3: Test the drain pump operation

    With the machine empty, run a short cycle and listen for the drain pump. If you hear a humming sound but no water is being expelled, the pump may be faulty and require replacement.

    If the pump is silent, it may need to be tested for electrical continuity.

  4. Step 4: Check for blockages in the drain line

    Disconnect the drain hose from the back of the washer and inspect it for any blockages. You can use a long flexible brush or a plumbing snake to clear any obstructions.

    Ensure the hose is reattached securely after cleaning.

  5. Step 5: Run a diagnostic test

    If the issue persists, run a diagnostic test by pressing the 'Start' and 'Pause' buttons in sequence to check for additional error codes that may provide further insight.

    Refer to your user manual for specific diagnostic procedures.

How to Reset

To reset the Ld error, unplug the washing machine for 1 minute, then plug it back in and run a short cycle to see if the error clears.

Technical Specifications

wattage 60W
component Drain Pump
resistance 10-30 ohms
part_number W10730972
voltage_rating 120V AC

Frequently Asked Questions

Can I fix the Ld error myself?

Yes, most homeowners can resolve the Ld error by cleaning the drain filter and checking the drain hose.

How long does it take to fix the Ld error?

Typically, fixing the Ld error takes about 30-45 minutes, depending on the issue.

What causes the Ld error in my washing machine?

The Ld error is usually caused by a clogged drain filter, a faulty drain pump, or a kinked drain hose.

Should I call a technician for the Ld error?

If you've cleaned the filter and checked the hose but the error persists, it may be time to call a technician to inspect the drain pump.

When should I consider replacing the drain pump?

If the pump is making a humming noise but not draining water, it may need to be replaced.

User Comments (0)

Share your experience or solution below.

Be the first to comment!