Whirlpool Washing Machine Error F8E3

⚡ Quick Answer: The Whirlpool Washing Machine error F8E3 signifies an overflow condition detected by the water level sensor. This leads to excessive water in the tub,... ✅ DIY Fixable

What Does Error F8E3 Mean?

The Whirlpool Washing Machine error F8E3 signifies an overflow condition detected by the water level sensor. This leads to excessive water in the tub, causing the wash cycle to stop mid-cycle and preventing the machine from starting. Clogged drain pumps or hoses may also contribute to this issue.

Common Symptoms:

  • Wash cycle stops mid‑cycle
  • Excessive water in tub
  • Water not draining properly
  • Error displayed when water level is above safe threshold

Possible Causes

  • Water level overfill condition (sensor detects too much water) (medium)
  • Clogged or obstructed drain pump or drain hose (medium)

How to Fix Error F8E3

DIY Fix Power Reset

  1. Unplug the washer from its power source.
  2. Wait at least 5 minutes.
  3. Plug it back in and restart a cycle.

DIY Fix Check Drain Pump and Hose for Blockages

  1. Turn off and unplug the washer.
  2. Locate and disconnect the drain hose; check for clogs or kinks.
  3. Inspect drain pump filter for debris and clean it out.
  4. Reassemble and test cycle.

DIY Fix Verify Inlet Valve Operation

  1. Turn off water supply to the washer.
  2. Inspect inlet hoses and valve for leaks or dripping.
  3. If obvious leakage persists, consider replacement (see technician action).

Technician Only Test/Replace Pressure Sensor (Water Level Sensor)

  1. Disconnect washer from power.
  2. Access the pressure sensor and associated hose.
  3. Test continuity and correct readings with multimeter.
  4. Replace sensor if faulty.

Parts needed: Pressure sensor (water level sensor), Associated hose/connectors

Technician Only Inspect/Replace Water Inlet Valve

  1. Power off and disconnect washer.
  2. Remove access panel to reach water inlet valve.
  3. Test valve coils for correct operation.
  4. Replace valve if defective.

Parts needed: Water inlet valve assembly

🛑 When to Call a Pro:
  • If you are unable to safely access components like drain pump, sensors, or inlet valve.
  • If error persists after basic checks and resets.
  • If there is evidence of water leakage inside the washer cabinet.

Technical Specifications

wattage N/A
component Door Lock Assembly
resistance 10-20 ohms
part_number W10810403
voltage_rating 120V AC

Common Questions

What does F8E3 error mean on Whirlpool Washing Machine?

F8E3 indicates an overflow condition where the water level sensor detects too much water, causing the cycle to stop.

Can I fix Whirlpool Washing Machine F8E3 error myself?

Yes, you can perform a power reset or check for blockages in the drain pump and hose.

How much does it cost to fix F8E3 error?

Repair costs for the F8E3 error range from $50 to $150 depending on parts and labor.

When should I call a technician for F8E3?

Call a technician if basic checks fail, or if you notice water leakage inside the washer.

Sources & References

Data last verified: 2026-01-10

User Comments (0)

Share your experience or solution below.

Be the first to comment!