Whirlpool Washing Machine Error F8E2

⚡ Quick Answer: F8E2 means Whirlpool Washing Machine error F8E2 indicates a malfunction in the water level sensor, which may cause the machine to f... This is typically a DIY fix.

What Does Error F8E2 Mean?

Whirlpool Washing Machine error F8E2 indicates a malfunction in the water level sensor, which may cause the machine to fail to fill or drain properly.

Common Causes

  • Water Level Sensor (50% likelihood)
  • Wiring Issues (30% likelihood)
  • Control Board Failure (20% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Water Level Sensor

    Locate the water level sensor, usually found near the top of the tub. Check for any visible signs of damage or blockage. Clean any debris that may be obstructing it.

    Ensure the machine is empty before inspection.

  2. Step 2: Test the Sensor with a Multimeter

    Disconnect the sensor's wiring harness and use a multimeter to check for continuity. A reading of 0 ohms indicates a good sensor; if not, the sensor needs replacement.

    Refer to the service manual for specific resistance values.

  3. Step 3: Check Wiring Connections

    Inspect the wiring harness connected to the water level sensor for any signs of wear or disconnection. Secure any loose connections or replace damaged wires.

    Ensure connections are tight to avoid future issues.

  4. Step 4: Examine the Control Board

    If the sensor and wiring are intact, check the control board for any burnt components or loose connections. If found, consider replacing the control board.

    This step may require professional assistance.

  5. Step 5: Run a Diagnostic Test

    After repairs, run a diagnostic test cycle to ensure the error code has cleared and the machine operates correctly.

    Refer to the user manual for diagnostic procedures.

How to Reset

To reset the F8E2 error, unplug the washing machine for 1 minute, then plug it back in and run a diagnostic cycle.

Technical Specifications

wattage N/A
component Water Level Sensor
resistance 5-10 ohms
part_number W10648030
voltage_rating 120V AC

Frequently Asked Questions

Can I fix the F8E2 error myself?

Yes, with basic tools and some technical knowledge, you can troubleshoot and fix the water level sensor.

How much does it cost to replace the water level sensor?

The cost of a new water level sensor typically ranges from $20 to $50, plus any labor if you hire a technician.

What causes the F8E2 error to appear?

The F8E2 error is usually caused by a malfunctioning water level sensor, wiring issues, or a faulty control board.

Should I call a professional for the F8E2 error?

If you are uncomfortable with electrical components or if the control board is suspected to be faulty, it’s best to consult a professional.

When should I expect the F8E2 error to clear?

The error should clear after resolving the underlying issue, such as replacing the sensor or fixing wiring connections.

User Comments (0)

Share your experience or solution below.

Be the first to comment!