Whirlpool Washing Machine Error F32

⚡ Quick Answer: F32 means Whirlpool Washing Machine error F32 indicates a failure in the door lock mechanism, often resulting in the door not lock... This is typically a DIY fix.

What Does Error F32 Mean?

Whirlpool Washing Machine error F32 indicates a failure in the door lock mechanism, often resulting in the door not locking properly and the machine being unable to start.

Common Causes

  • Door Lock Assembly (50% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Door Lock Mechanism

    Open the washer door and check the door lock for any visible damage or debris. Ensure that the latch moves freely and is not obstructed.

    Clean any debris that may be preventing the latch from operating.

  2. Step 2: Test the Door Lock Assembly

    Use a multimeter to check the continuity of the door lock assembly. Disconnect the wires and measure resistance across the terminals. If it reads infinite resistance, the part is faulty.

    Replace the door lock assembly if it fails the continuity test.

  3. Step 3: Reassemble and Test the Washer

    Reattach the door lock assembly and secure the screws. Close the door and run a short cycle to test if the error code F32 has cleared.

    Ensure the door closes properly to avoid future errors.

How to Reset

To reset the F32 error, unplug the washer for 1 minute, then plug it back in and attempt to start a cycle again.

Technical Specifications

wattage N/A
component Door Lock Assembly
resistance 500-1000 ohms
part_number W10810403
voltage_rating 120V AC

Frequently Asked Questions

Can I fix the F32 error myself?

Yes, if you have basic tools and can follow instructions, you can replace the door lock assembly.

How long does it take to fix the F32 error?

The repair typically takes about 45-60 minutes, depending on your experience.

What causes the F32 error in my Whirlpool washer?

The F32 error is usually caused by a malfunctioning door lock assembly that fails to secure the door.

Should I replace the door lock assembly immediately?

Yes, if the door lock assembly is faulty, it should be replaced to restore normal operation.

What happens if I ignore the F32 error?

Ignoring the F32 error may prevent the washer from operating, leading to further issues and potential water leaks.

User Comments (0)

Share your experience or solution below.

Be the first to comment!