Whirlpool Washing Machine Error F1E2

⚡ Quick Answer: F1E2 means Whirlpool Washing Machine error F1E2 indicates a failure in the control board, which may cause the machine to display er... This is typically a DIY fix.

What Does Error F1E2 Mean?

Whirlpool Washing Machine error F1E2 indicates a failure in the control board, which may cause the machine to display erratic behavior or fail to start.

Common Causes

  • Control Board (60% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Control Board for Damage

    Open the control panel and visually inspect the control board for burnt components or loose connections.

    Look for any discoloration or smell of burnt electronics.

  2. Step 2: Test the Control Board with a Multimeter

    Use a multimeter to check for continuity in the control board's circuits. If there’s no continuity, the board needs replacement.

    Ensure you are testing the correct terminals as per the wiring diagram.

  3. Step 3: Replace the Control Board if Necessary

    If the control board is faulty, disconnect the wiring harness and screws, then replace it with a new board.

    Make sure to reconnect all wires in the same configuration.

  4. Step 4: Reassemble the Washing Machine

    Once the new control board is installed, reassemble the control panel and secure all screws.

    Double-check all connections before powering on.

  5. Step 5: Run a Diagnostic Test

    After reassembly, run a diagnostic cycle to ensure the error code has cleared and the machine operates correctly.

    Refer to the user manual for specific diagnostic test instructions.

How to Reset

To reset the F1E2 error, unplug the washing machine for 10 minutes, then plug it back in and run a diagnostic test.

Technical Specifications

wattage N/A
component Control Board
resistance N/A
part_number W10675028
voltage_rating 120V AC

Frequently Asked Questions

Can I replace the control board myself?

Yes, if you have basic electrical skills and the right tools, you can replace the control board.

How much does a control board replacement cost?

The cost of a control board typically ranges from $100 to $300, depending on the model.

What causes the F1E2 error in my washing machine?

The F1E2 error is usually caused by a malfunctioning control board due to electrical surges or component failure.

Should I call a professional for the F1E2 error?

If you're uncomfortable with electrical repairs or if the issue persists after replacement, it's best to call a professional.

When should I consider replacing my washing machine?

If the control board fails multiple times or if the repair costs exceed half the machine's value, consider replacement.

User Comments (0)

Share your experience or solution below.

Be the first to comment!