Whirlpool Washing Machine Error F1E1

⚡ Quick Answer: The Whirlpool Washing Machine F1E1 error code indicates a malfunction in the control board, which can cause the washer to stop mid-cycle or fail to st... ✅ DIY Fixable

What Does Error F1E1 Mean?

The Whirlpool Washing Machine F1E1 error code indicates a malfunction in the control board, which can cause the washer to stop mid-cycle or fail to start. This error may arise from an internal fault or a temporary communication glitch. A power reset can sometimes resolve the issue, but if it persists, further diagnosis and repair by a technician may be necessary.

Common Symptoms:

  • Washer stops mid‑cycle
  • Error code F1E1 shown on display
  • Washer not progressing through wash cycle

Possible Causes

  • Control board or electronic fault detected by internal diagnostics (medium)
  • Temporary communication glitch or software anomaly (medium)

How to Fix Error F1E1

DIY Fix Perform a power reset

  1. Unplug the washer from the power outlet or turn off its circuit breaker.
  2. Wait at least 5 minutes to allow the internal electronics to fully discharge.
  3. Restore power and attempt to run a cycle to see if the error clears.

Technician Only Inspect and diagnose control electronics

  1. Verify proper voltage supply at the washer’s power input.
  2. Check wiring harnesses and connectors between the main control board and user interface board for damage or loose connections.
  3. Test or replace the main control board if diagnostics indicate failure.

Parts needed: Main control board, User interface control board, Wiring harness/connectors

🛑 When to Call a Pro:
  • If the error persists after a proper power reset.
  • If additional errors accompany F1E1 or the washer fails to operate normally.

Technical Specifications

wattage 200W
component Control Board
resistance 5-15 ohms
part_number W10675028
voltage_rating 120V AC

Common Questions

What does F1E1 error mean on Whirlpool Washing Machine?

F1E1 indicates a control board malfunction, causing the washer to stop or not start.

Can I fix Whirlpool Washing Machine F1E1 error myself?

Yes, you can attempt a power reset by unplugging the washer for at least 5 minutes.

How much does it cost to fix F1E1 error?

Estimated repair costs for F1E1 range from ¥15,000 to ¥45,000, depending on parts and labor.

When should I call a technician for F1E1?

Call a technician if the error persists after a reset or if other issues arise.

Sources & References

Data last verified: 2026-01-10

User Comments (0)

Share your experience or solution below.

Be the first to comment!