Whirlpool Washing Machine Error F10

⚡ Quick Answer: The Whirlpool Washing Machine error code F10 indicates an issue with the Motor Control Unit (MCU), which may have overheated due to excessive load or ... ⚠️ Difficulty Varies

What Does Error F10 Mean?

The Whirlpool Washing Machine error code F10 indicates an issue with the Motor Control Unit (MCU), which may have overheated due to excessive load or restricted ventilation. This malfunction prevents the washer from filling or draining properly and can stop motor functions during cycles. If the error persists, it suggests internal protection mechanisms have been triggered, requiring thorough inspection and potential repairs.

Common Symptoms:

  • Washer displays F10 code on control panel
  • Motor functions stop or reduced during cycle
  • Error appears after heavy loads or long motor use
  • Machine may not complete cycles due to motor shutdown

Possible Causes

  • Motor Control Unit (MCU) Overheat/Heat Sink Thermal Trip (medium)
  • Restricted ventilation/installation causing MCU overheating (medium)
  • Drive system mechanical friction or overload (low)

How to Fix Error F10

DIY Fix Check Installation and Ventilation

  1. Ensure washer has adequate clearance on all sides for airflow.
  2. Verify machine is not tightly pushed against walls or inside a confined space.
  3. Remove any visible obstructions near ventilation points.

DIY Fix Restart and Observe

  1. Turn off and unplug the washer.
  2. Wait a few minutes to allow internal components to cool.
  3. Plug back in and restart a light cycle to see if code reappears.

Technician Only Inspect Motor Control and Drive System

  1. Remove access panels and inspect MCU and wiring harnesses for damage or loose connections.
  2. Check motor windings and drive components for wear, friction, or binding that may cause overload.
  3. Measure resistance and continuity on motor and MCU as per service manual specifications.

Parts needed: Motor Control Unit (MCU), Drive Motor, Wiring Harness

🛑 When to Call a Pro:
  • If error persists after basic ventilation and reset attempts
  • If wiring, motor, or control board components appear damaged
  • If the machine overheats or displays F10 repeatedly even with normal loads

Technical Specifications

wattage N/A
component Water Level Sensor
resistance 5-15 ohms
part_number W10503083
voltage_rating 120V AC

Common Questions

What does F10 error mean on Whirlpool Washing Machine?

F10 signifies a malfunction in the Motor Control Unit due to overheating, affecting the washer's ability to fill and drain.

Can I fix Whirlpool Washing Machine F10 error myself?

Yes, check installation for proper ventilation and restart the machine to see if the error persists.

How much does it cost to fix F10 error?

Repair costs typically range from $150 to $500 depending on parts and labor required.

When should I call a technician for F10?

Call a technician if the error continues after troubleshooting, or if you notice any damage to wiring or components.

Data last verified: 2026-01-10

User Comments (0)

Share your experience or solution below.

Be the first to comment!