Whirlpool Oven Error F10

⚡ Quick Answer: F10 means Whirlpool Oven error F10 indicates a malfunction in the temperature sensor, often resulting in erratic temperature readi... This is typically a DIY fix.

What Does Error F10 Mean?

Whirlpool Oven error F10 indicates a malfunction in the temperature sensor, often resulting in erratic temperature readings or the oven failing to heat properly.

Common Causes

  • Temperature Sensor (60% likelihood)
  • Wiring Issues (30% likelihood)
  • Control Board Malfunction (10% likelihood)

Troubleshooting Steps

  1. Step 1: Inspect the Temperature Sensor

    Remove the oven's back panel to access the temperature sensor. Use a multimeter to test the sensor's resistance. It should read between 1,000 to 1,200 ohms at room temperature. If the reading is outside this range, replace the sensor.

    Ensure the oven is completely cool before starting.

  2. Step 2: Check Wiring Connections

    Examine the wiring connected to the temperature sensor for any signs of damage or loose connections. Repair or replace any faulty wiring as necessary.

    Secure all connections with insulation tape to prevent future issues.

  3. Step 3: Test the Control Board

    If the temperature sensor and wiring are intact, check the control board for any visible damage or burnt components. If necessary, consult the service manual for testing procedures or consider replacing the control board.

    This step may require professional assistance if you're unfamiliar with electronics.

How to Reset

To reset the F10 error code, turn off the oven at the circuit breaker for 5 minutes, then restore power and check if the error persists.

Technical Specifications

wattage N/A
component Temperature Sensor
resistance 1,000-1,200 ohms
part_number W10823600
voltage_rating 120V AC

Frequently Asked Questions

Can I continue using my oven with the F10 error?

It's not recommended, as it may lead to further damage or unsafe cooking conditions.

How much does it cost to replace the temperature sensor?

The cost for a replacement temperature sensor typically ranges from $30 to $100, depending on the model.

What causes the F10 error to appear?

The F10 error usually results from a faulty temperature sensor, wiring issues, or a malfunctioning control board.

Should I attempt to fix the F10 error myself?

If you have basic electrical knowledge and tools, you can attempt the repair. Otherwise, it's best to call a professional.

When should I consider replacing the control board?

If both the temperature sensor and wiring are functioning correctly, and the F10 error persists, it may indicate a faulty control board.

User Comments (0)

Share your experience or solution below.

Be the first to comment!