Westinghouse Refrigerator Error F1
⚡ Quick Answer: The Westinghouse refrigerator error code F1 signifies a potential failure in the temperature sensor, leading to erratic temperature readings and possi... ✅ DIY Fixable
What Does Error F1 Mean?
The Westinghouse refrigerator error code F1 signifies a potential failure in the temperature sensor, leading to erratic temperature readings and possible cooling issues. This may result in the refrigerator not maintaining the desired temperature, which can affect food preservation. If the F1 code is displayed, it is crucial to address the issue promptly to avoid further complications.
Common Symptoms:
- Error code F1 displayed on control panel (general refrigerators)
- Refrigerator may stop cooling or show abnormal temperature readings (generic reports)
Possible Causes
- Temperature Sensor
How to Fix Error F1
DIY Fix Basic checks & power reset
- Unplug the refrigerator from power for 5–10 minutes and plug it back in to attempt a reset.
- Ensure the refrigerator is properly plugged in and power is supplied.
- Check for obvious loose wiring around the control panel or display (only if safely accessible).
Technician Only Diagnostic inspection of sensors and control electronics
- Use a multimeter to test temperature sensors (NTC thermistors) for open or short circuits (generic fridge troubleshooting guidance).
- Inspect and test communication signals between the display/control interface and main control board.
- Replace any defective temperature sensors or control boards as identified.
Parts needed: Temperature sensor (NTC thermistor), Control board / main PCB, Display/interface board
- If error persists after a power reset.
- If you are uncomfortable handling electrical components.
- If the refrigerator exhibits warm temperatures or cooling failure with the F1 code displayed.
Next step
Choose the next step for F1
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Temperature Sensor
Monitors the internal temperature to ensure correct operation and prevent overheating.
- Typical part-only price
- $15 - $35
- DIY difficulty
- Easy
- Estimated time
- 15-30 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Main Control Board
The central brain of the appliance that controls all components, cycles, and timings.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | N/A |
|---|---|
| component | Temperature Sensor |
| resistance | 5-10 kΩ |
| part_number | W10823804 |
| voltage_rating | 120V AC |
Common Questions
What does F1 error mean on westinghouse refrigerator?
F1 indicates a potential failure in the temperature sensor, causing erratic temperature readings.
Can I fix westinghouse refrigerator F1 error myself?
Yes, try unplugging the refrigerator for 5-10 minutes to reset it and check for loose wiring.
How much does it cost to fix F1 error?
Repair costs vary widely; replacing the control board may cost several hundred USD.
When should I call a technician for F1?
Call a technician if the error persists after a reset or if you're uncomfortable handling electrical components.
Sources & References
Data last verified: 2026-03-09
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!